[PATCH v3 0/4] media: rcar-csi2: Add D-PHY support for V4H`

["Niklas Söderlund" <niklas.soderlund+renesas@ragnatech.se>]

Hello,

This series adds support for CSI-2 D-PHY reception on R-Car Gen4 V4H
devices. Previously only C-PHY reception was supported due lack of 
documentation and no hardware to test D-PHY on.

Later revisions of the datasheet (Rev.1.21) describes the start-up
procedure in some detail, and we now have hardware to test on! The
documentation however only sparsely documents the registers involved and
instead mostly document magic values and an order to write them to
register offsets without much documentation.

This series tries to in the extend possible to at least used named
register and use formulas and lookup tables to make some sens of the
magic values. Still most of them comes of a table of magic values in the
datasheet.

Patch 1/4 clears up a unfortunate mix of the name mbps (mega bits per
second) used in the D-PHY context and msps (mega symbols per second)
used in the C-PHY context.

Patch 2/4 and 3/4 prepares for adding D-PHY support by cleaning up
register names and an updated common startup procedure for V4H which
have been revised in later versions of the datasheet since the initial
C-PHY V4H support was added.

Finally patch 4/4 adds D-PHY support.

The work is tested at many different link speed and number of
lanes. In 2-lane mode using an IMX219 and in 4-lane mode using IMX462
sensors.

See individual patches for change log.

Niklas Söderlund (4):
  media: rcar-csi2: Clarify usage of mbps and msps
  media: rcar-csi2: Rework macros to access AFE lanes
  media: rcar-csi2: Update start procedure for V4H
  media: rcar-csi2: Add D-PHY support for V4H

 drivers/media/platform/renesas/rcar-csi2.c | 342 ++++++++++++++++++---
 1 file changed, 297 insertions(+), 45 deletions(-)

-- 
2.49.0