Re: [PATCH v2 net-next] amd-xgbe: Configure and retrieve 'tx-usecs' for Tx coalescing

[Jakub Kicinski <kuba@kernel.org>]

On Tue, 12 Aug 2025 10:20:35 +0530 Vishal Badole wrote:
> Ethtool has advanced with additional configurable options, but the
> current driver does not support tx-usecs configuration.

Not sure what you mean by this, perhaps:

  current driver does not even support tx-usecs configuration.

? tx-usecs is a very old tunable.

> Add support to configure and retrieve 'tx-usecs' using ethtool, which
> specifies the wait time before servicing an interrupt for Tx coalescing.
> 

> +	/* Check if both tx_usecs and tx_frames are set to 0 simultaneously */
> +	if (!tx_usecs && !tx_frames) {
> +		NL_SET_ERR_MSG_FMT_MOD(extack,
> +				       "tx_usecs and tx_frames must not be 0 together");
> +		return -EINVAL;
> +	}
> +
>  	/* Check the bounds of values for Tx */
> +	if (tx_usecs > XGMAC_MAX_COAL_TX_TICK) {
> +		NL_SET_ERR_MSG_FMT_MOD(extack, "tx-usecs is limited to %d usec",
> +				       XGMAC_MAX_COAL_TX_TICK);
> +		return -EINVAL;
> +	}

Normal configuration granularity for this parameter is in 10s of usecs.
You seem to be using a timer, so I think you should either round the
value up / down to what the jiffy resolution will give you or
reject configuration that's not expressible in jiffies (not a multiple
of jiffies_to_usecs(1)). Otherwise users may waste time turning this
knob by 100usec which will have zero effect.
-- 
pw-bot: cr