[PATCH net-next] net: phylink: remove stale an_enabled from doc

[David Yang <mmyangfl@gmail.com>]

state->an_enabled was removed before, but is left in mac_config() doc,
so clean it.

Fixes: 4ee9b0dcf09f ("net: phylink: remove an_enabled")
Signed-off-by: David Yang <mmyangfl@gmail.com>
---
 include/linux/phylink.h | 7 +++----
 1 file changed, 3 insertions(+), 4 deletions(-)

diff --git a/include/linux/phylink.h b/include/linux/phylink.h
index 30659b615fca..9af0411761d7 100644
--- a/include/linux/phylink.h
+++ b/include/linux/phylink.h
@@ -320,9 +320,8 @@ int mac_prepare(struct phylink_config *config, unsigned int mode,
  *   If in 802.3z mode, the link speed is fixed, dependent on the
  *   @state->interface. Duplex and pause modes are negotiated via
  *   the in-band configuration word. Advertised pause modes are set
- *   according to the @state->an_enabled and @state->advertising
- *   flags. Beware of MACs which only support full duplex at gigabit
- *   and higher speeds.
+ *   according to @state->advertising. Beware of MACs which only
+ *   support full duplex at gigabit and higher speeds.
  *
  *   If in Cisco SGMII mode, the link speed and duplex mode are passed
  *   in the serial bitstream 16-bit configuration word, and the MAC
@@ -331,7 +330,7 @@ int mac_prepare(struct phylink_config *config, unsigned int mode,
  *   responsible for reading the configuration word and configuring
  *   itself accordingly.
  *
- *   Valid state members: interface, an_enabled, pause, advertising.
+ *   Valid state members: interface, pause, advertising.
  *
  * Implementations are expected to update the MAC to reflect the
  * requested settings - i.o.w., if nothing has changed between two
-- 
2.50.1