[PATCH] drm/bridge: analogix_dp: Fix connector status detection for bridges

[Heiko Stuebner <heiko@sntech.de>]

Right now if there is a next bridge attached to the analogix-dp controller
the driver always assumes this bridge is connected to something, but this
is of course not always true, as that bridge could also be a hotpluggable
dp port for example.

On the other hand, as stated in commit cb640b2ca546 ("drm/bridge: display-
connector: don't set OP_DETECT for DisplayPorts"), "Detecting the monitor
for DisplayPort targets is more complicated than just reading the HPD pin
level" and we should be "letting the actual DP driver perform detection."

So use drm_bridge_detect() to detect the next bridge's state but ignore
that bridge if the analogix-dp is handling the hpd-gpio.

Signed-off-by: Heiko Stuebner <heiko@sntech.de>
---
As this patch stands, it would go on top of v6 of Damon's bridge-connector
work, but could very well be also integrated into one of the changes there.

I don't know yet if my ordering and/or reasoning is the correct one or if
a better handling could be done, but with that change I do get a nice
hotplug behaviour on my rk3588-tiger-dp-carrier board, where the
Analogix-DP ends in a full size DP port.

 drivers/gpu/drm/bridge/analogix/analogix_dp_core.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
index c04b5829712b..cdc56e83b576 100644
--- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
+++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
@@ -983,8 +983,12 @@ analogix_dp_bridge_detect(struct drm_bridge *bridge, struct drm_connector *conne
 	struct analogix_dp_device *dp = to_dp(bridge);
 	enum drm_connector_status status = connector_status_disconnected;
 
-	if (dp->plat_data->next_bridge)
-		return connector_status_connected;
+	/*
+	 * An optional next bridge should be in charge of detection the
+	 * connection status, except if we manage a actual hpd gpio.
+	 */
+	if (dp->plat_data->next_bridge && !dp->hpd_gpiod)
+		return drm_bridge_detect(dp->plat_data->next_bridge, connector);
 
 	if (!analogix_dp_detect_hpd(dp))
 		status = connector_status_connected;
-- 
2.47.2