From: Heiko Stuebner <heiko@sntech.de>
To: heiko@sntech.de
Cc: robh@kernel.org, krzk+dt@kernel.org, conor+dt@kernel.org,
quentin.schulz@cherry.de, devicetree@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org,
damon.ding@rock-chips.com,
Heiko Stuebner <heiko.stuebner@cherry.de>
Subject: [PATCH v4 2/2] arm64: dts: rockchip: add RK3588 DP carrier from Theobroma Systems
Date: Fri, 10 Oct 2025 00:50:50 +0200 [thread overview]
Message-ID: <20251009225050.88192-3-heiko@sntech.de> (raw)
In-Reply-To: <20251009225050.88192-1-heiko@sntech.de>
From: Heiko Stuebner <heiko.stuebner@cherry.de>
The DisplayPort carrier is a very simple baseboard only providing serial,
ethernet and a displayport output.
But its main functionality is that it routes the Analogix eDP controller
to this DisplayPort output, which allows to test that controller simply
by hooking it up to a suitable monitor.
The Analogix-DP controller supports eDP 1.3 and DP 1.2, so can drive
both eDP displays as well as full DP monitors. It does not support DP+
so passive DP-to-HDMI adapters won't work.
Signed-off-by: Heiko Stuebner <heiko.stuebner@cherry.de>
Link: https://lore.kernel.org/r/20250723190904.37792-3-heiko@sntech.de
---
arch/arm64/boot/dts/rockchip/Makefile | 1 +
.../rk3588-tiger-displayport-carrier.dts | 119 ++++++++++++++++++
2 files changed, 120 insertions(+)
create mode 100644 arch/arm64/boot/dts/rockchip/rk3588-tiger-displayport-carrier.dts
diff --git a/arch/arm64/boot/dts/rockchip/Makefile b/arch/arm64/boot/dts/rockchip/Makefile
index ad684e3831bc..3a1739b8f167 100644
--- a/arch/arm64/boot/dts/rockchip/Makefile
+++ b/arch/arm64/boot/dts/rockchip/Makefile
@@ -188,6 +188,7 @@ dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-rock-5b-pcie-ep.dtbo
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-rock-5b-pcie-srns.dtbo
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-rock-5b-plus.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-rock-5t.dtb
+dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-tiger-displayport-carrier.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-tiger-haikou.dtb
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-tiger-haikou-video-demo.dtbo
dtb-$(CONFIG_ARCH_ROCKCHIP) += rk3588-toybrick-x0.dtb
diff --git a/arch/arm64/boot/dts/rockchip/rk3588-tiger-displayport-carrier.dts b/arch/arm64/boot/dts/rockchip/rk3588-tiger-displayport-carrier.dts
new file mode 100644
index 000000000000..c14718bc4fda
--- /dev/null
+++ b/arch/arm64/boot/dts/rockchip/rk3588-tiger-displayport-carrier.dts
@@ -0,0 +1,119 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (c) 2024 Cherry Embedded Solutions GmbH
+ */
+
+/dts-v1/;
+#include <dt-bindings/soc/rockchip,vop2.h>
+#include "rk3588-tiger.dtsi"
+
+/ {
+ model = "Theobroma Systems RK3588-Q7 SoM on Tiger Displayport Carrier v1";
+ compatible = "tsd,rk3588-tiger-displayport-carrier", "tsd,rk3588-tiger", "rockchip,rk3588";
+
+ aliases {
+ ethernet0 = &gmac0;
+ };
+
+ chosen {
+ stdout-path = "serial2:115200n8";
+ };
+
+ dp-connector {
+ compatible = "dp-connector";
+ dp-pwr-supply = <&vcc3v3_baseboard>;
+ label = "dp0";
+ type = "full-size";
+
+ port {
+ dp_con_in: endpoint {
+ remote-endpoint = <&edp0_out_con>;
+ };
+ };
+ };
+
+ vcc3v3_baseboard: regulator-vcc3v3-baseboard {
+ compatible = "regulator-fixed";
+ regulator-name = "vcc3v3_baseboard";
+ regulator-always-on;
+ regulator-boot-on;
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ vin-supply = <&vcc5v0_baseboard>;
+ };
+
+ vcc5v0_baseboard: regulator-vcc5v0-baseboard {
+ compatible = "regulator-fixed";
+ regulator-name = "vcc5v0_baseboard";
+ regulator-always-on;
+ regulator-boot-on;
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ };
+};
+
+&edp0 {
+ /*
+ * Q7_DP_HPD# but Q7_HDMI_HPD# could be used too
+ *
+ * HPD handling in the Analogix-DP not in dp-connector, because
+ * "Detecting the monitor for DisplayPort targets is more
+ * complicated than just reading the HPD pin level" so the
+ * "actual DP driver (should) perform detection".
+ * For reference see commit cb640b2ca546 ("drm/bridge:
+ * display-connector: don't set OP_DETECT for DisplayPorts")
+ * in the Linux-kernel.
+ */
+ hpd-gpios = <&gpio4 RK_PB5 GPIO_ACTIVE_LOW>;
+ pinctrl-0 = <&edp0_hpd_l>;
+ pinctrl-names = "default";
+ status = "okay";
+};
+
+&edp0_in {
+ edp0_in_vp2: endpoint {
+ remote-endpoint = <&vp2_out_edp0>;
+ };
+};
+
+&edp0_out {
+ edp0_out_con: endpoint {
+ remote-endpoint = <&dp_con_in>;
+ };
+};
+
+&gmac0 {
+ status = "okay";
+};
+
+&hdptxphy0 {
+ status = "okay";
+};
+
+&pinctrl {
+ edp0 {
+ edp0_hpd_l: edp0-hpd-l-pin {
+ rockchip,pins = <4 RK_PB5 RK_FUNC_GPIO &pcfg_pull_up>;
+ };
+ };
+};
+
+&uart2 {
+ pinctrl-0 = <&uart2m2_xfer>;
+ status = "okay";
+};
+
+&vop {
+ status = "okay";
+};
+
+&vop_mmu {
+ status = "okay";
+};
+
+&vp2 {
+ vp2_out_edp0: endpoint@ROCKCHIP_VOP2_EP_EDP0 {
+ reg = <ROCKCHIP_VOP2_EP_EDP0>;
+ remote-endpoint = <&edp0_in_vp2>;
+ };
+};
--
2.47.2
next prev parent reply other threads:[~2025-10-09 22:51 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-10-09 22:50 [PATCH v4 0/2] Add RK3588 Tiger DisplayPort carrier Heiko Stuebner
2025-10-09 22:50 ` [PATCH v4 1/2] dt-bindings: arm: rockchip: add RK3588 DP carrier from Theobroma Systems Heiko Stuebner
2025-10-10 1:51 ` Krzysztof Kozlowski
2025-10-09 22:50 ` Heiko Stuebner [this message]
2025-10-15 14:32 ` [PATCH v4 2/2] arm64: dts: " Quentin Schulz
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20251009225050.88192-3-heiko@sntech.de \
--to=heiko@sntech.de \
--cc=conor+dt@kernel.org \
--cc=damon.ding@rock-chips.com \
--cc=devicetree@vger.kernel.org \
--cc=heiko.stuebner@cherry.de \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=quentin.schulz@cherry.de \
--cc=robh@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®