[PATCH] net: phy: fix doc for rgii_clock()

[Maud Spierings via B4 Relay <devnull+maudspierings.gocontroll.com@kernel.org>]

From: Maud Spierings <maudspierings@gocontroll.com>

The doc states that the clock values also apply to the rmii mode,
"as the clock rates are identical". But as far as I can find the
clock rate for rmii is 50M at both 10 and 100 mbits/s [1].

Link: https://en.wikipedia.org/wiki/Media-independent_interface [1]

Signed-off-by: Maud Spierings <maudspierings@gocontroll.com>
---
This patch is also part question, I am working on an imx8mp based device
with the dwmac-imx driver. In imx_dwmac_set_clk_tx_rate() and
imx_dwmac_fix_speed() both rmii and mii are excluded from setting the
clock rate with this function.

But from what I can read only rmii should be excluded, I am not very
knowledgable with regards to networkinging stuff so my info is
coming from wikipedia.

I am adding this exclusion to the barebox bootloader, but I am not sure
if I should also be excluding mii as is being done upstream.
---
 include/linux/phy.h | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/include/linux/phy.h b/include/linux/phy.h
index bf5457341ca8..e941b280c196 100644
--- a/include/linux/phy.h
+++ b/include/linux/phy.h
@@ -296,9 +296,9 @@ static inline const char *phy_modes(phy_interface_t interface)
  * @speed: link speed value
  *
  * Description: maps RGMII supported link speeds into the clock rates.
- * This can also be used for MII, GMII, and RMII interface modes as the
- * clock rates are identical, but the caller must be aware that errors
- * for unsupported clock rates will not be signalled.
+ * This can also be used for MII and GMII interface modes as the clock rates
+ * are identical, but the caller must be aware that errors for unsupported
+ * clock rates will not be signalled.
  *
  * Returns: clock rate or negative errno
  */

---
base-commit: 0f2995693867bfb26197b117cd55624ddc57582f
change-id: 20251114-rgmii_clock-1389d0667bf7

Best regards,
-- 
Maud Spierings <maudspierings@gocontroll.com>