[PATCH] eeprom: at24: use dev_err_probe() consistently

[Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>]

Save some lines by consistently using dev_err_probe() when bailing out
with an error message.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>
---
 drivers/misc/eeprom/at24.c | 20 +++++++-------------
 1 file changed, 7 insertions(+), 13 deletions(-)

diff --git a/drivers/misc/eeprom/at24.c b/drivers/misc/eeprom/at24.c
index f721825199ce..0200288d3a7a 100644
--- a/drivers/misc/eeprom/at24.c
+++ b/drivers/misc/eeprom/at24.c
@@ -657,10 +657,8 @@ static int at24_probe(struct i2c_client *client)
 	if (!i2c_fn_i2c && !i2c_fn_block)
 		page_size = 1;
 
-	if (!page_size) {
-		dev_err(dev, "page_size must not be 0!\n");
-		return -EINVAL;
-	}
+	if (!page_size)
+		return dev_err_probe(dev, -EINVAL, "page_size must not be 0!\n");
 
 	if (!is_power_of_2(page_size))
 		dev_warn(dev, "page_size looks suspicious (no power of 2)!\n");
@@ -674,11 +672,9 @@ static int at24_probe(struct i2c_client *client)
 				(flags & AT24_FLAG_ADDR16) ? 65536 : 256);
 	}
 
-	if ((flags & AT24_FLAG_SERIAL) && (flags & AT24_FLAG_MAC)) {
-		dev_err(dev,
-			"invalid device data - cannot have both AT24_FLAG_SERIAL & AT24_FLAG_MAC.");
-		return -EINVAL;
-	}
+	if ((flags & AT24_FLAG_SERIAL) && (flags & AT24_FLAG_MAC))
+		return dev_err_probe(dev, -EINVAL,
+				     "invalid device data - cannot have both AT24_FLAG_SERIAL & AT24_FLAG_MAC.");
 
 	regmap_config.val_bits = 8;
 	regmap_config.reg_bits = (flags & AT24_FLAG_ADDR16) ? 16 : 8;
@@ -759,10 +755,8 @@ static int at24_probe(struct i2c_client *client)
 	full_power = acpi_dev_state_d0(&client->dev);
 	if (full_power) {
 		err = regulator_enable(at24->vcc_reg);
-		if (err) {
-			dev_err(dev, "Failed to enable vcc regulator\n");
-			return err;
-		}
+		if (err)
+			return dev_err_probe(dev, err, "Failed to enable vcc regulator\n");
 
 		pm_runtime_set_active(dev);
 	}
-- 
2.51.0