[PATCH 3/3] arm64: dts: amlogic: S4: Add the Mali-G31 GPU

[Martin Blumenstingl <martin.blumenstingl@googlemail.com>]

The vendor BSP indicates that the Mali-G31 GPU on Meson S4 SoCs is
similar to the setup on G12A SoCs. The OPP table and resets are the
same, but the clocks (G12A only has one, S4 has two) and interrupt
numbers are different.

Describe the Mali-G31 GPU with it's resources and enable it by default
since all frequencies are using the same voltage (as the GPU is supplied
by VDDEE changes to the VDDEE voltage are not needed at runtime).

Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
---
 arch/arm64/boot/dts/amlogic/meson-s4.dtsi | 49 +++++++++++++++++++++++
 1 file changed, 49 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/meson-s4.dtsi b/arch/arm64/boot/dts/amlogic/meson-s4.dtsi
index 9d99ed2994df..efd3dda7d2c1 100644
--- a/arch/arm64/boot/dts/amlogic/meson-s4.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-s4.dtsi
@@ -66,6 +66,39 @@ xtal: xtal-clk {
 		#clock-cells = <0>;
 	};
 
+	gpu_opp_table: opp-table-gpu {
+		compatible = "operating-points-v2";
+
+		opp-124999998 {
+			opp-hz = /bits/ 64 <124999998>;
+			opp-microvolt = <800000>;
+		};
+		opp-249999996 {
+			opp-hz = /bits/ 64 <249999996>;
+			opp-microvolt = <800000>;
+		};
+		opp-285714281 {
+			opp-hz = /bits/ 64 <285714281>;
+			opp-microvolt = <800000>;
+		};
+		opp-399999994 {
+			opp-hz = /bits/ 64 <399999994>;
+			opp-microvolt = <800000>;
+		};
+		opp-499999992 {
+			opp-hz = /bits/ 64 <499999992>;
+			opp-microvolt = <800000>;
+		};
+		opp-666666656 {
+			opp-hz = /bits/ 64 <666666656>;
+			opp-microvolt = <800000>;
+		};
+		opp-799999988 {
+			opp-hz = /bits/ 64 <799999988>;
+			opp-microvolt = <800000>;
+		};
+	};
+
 	firmware {
 		sm: secure-monitor {
 			compatible = "amlogic,meson-gxbb-sm";
@@ -783,6 +816,22 @@ ir: ir@84040 {
 				status = "disabled";
 			};
 
+			gpu: gpu@400000 {
+				compatible = "amlogic,meson-s4-mali", "arm,mali-bifrost";
+				reg = <0x00 0xfe400000 0x00 0x40000>;
+				interrupts = <GIC_SPI 146 IRQ_TYPE_LEVEL_HIGH>,
+					     <GIC_SPI 145 IRQ_TYPE_LEVEL_HIGH>,
+					     <GIC_SPI 144 IRQ_TYPE_LEVEL_HIGH>;
+				interrupt-names = "job", "mmu", "gpu";
+				clocks = <&clkc_periphs CLKID_MALI_SEL>,
+					 <&clkc_periphs CLKID_MALI>;
+				clock-names = "gpu", "bus";
+				resets = <&reset RESET_MALI>,
+					 <&reset RESET_MALI_APB>;
+				operating-points-v2 = <&gpu_opp_table>;
+				#cooling-cells = <2>;
+			};
+
 			hwrng: rng@440788 {
 				compatible = "amlogic,meson-s4-rng";
 				reg = <0x0 0x440788 0x0 0x0c>;
-- 
2.52.0