[PATCH v4 7/9] Bluetooth: hci_qca: Add M.2 Bluetooth device support using pwrseq

[Manivannan Sadhasivam via B4 Relay <devnull+manivannan.sadhasivam.oss.qualcomm.com@kernel.org>]

From: Manivannan Sadhasivam <manivannan.sadhasivam@oss.qualcomm.com>

Power supply to the M.2 Bluetooth device attached to the host using M.2
connector is controlled using the 'uart' pwrseq device. So add support for
getting the pwrseq device if the OF graph link is present. Once obtained,
the existing pwrseq APIs can be used to control the power supplies of the
M.2 card.

Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@oss.qualcomm.com>
---
 drivers/bluetooth/hci_qca.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index 888176b0faa9..4d562596ebf9 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -26,6 +26,7 @@
 #include <linux/mod_devicetable.h>
 #include <linux/module.h>
 #include <linux/of.h>
+#include <linux/of_graph.h>
 #include <linux/acpi.h>
 #include <linux/platform_device.h>
 #include <linux/pwrseq/consumer.h>
@@ -2384,6 +2385,14 @@ static int qca_serdev_probe(struct serdev_device *serdev)
 	case QCA_WCN6855:
 	case QCA_WCN7850:
 	case QCA_WCN6750:
+		if (of_graph_is_present(dev_of_node(&serdev->ctrl->dev))) {
+			qcadev->bt_power->pwrseq = devm_pwrseq_get(&serdev->ctrl->dev,
+								   "uart");
+			if (IS_ERR(qcadev->bt_power->pwrseq))
+				return PTR_ERR(qcadev->bt_power->pwrseq);
+			break;
+		}
+
 		if (!device_property_present(&serdev->dev, "enable-gpios")) {
 			/*
 			 * Backward compatibility with old DT sources. If the

-- 
2.48.1