From: Yongxing Mou <yongxing.mou@oss.qualcomm.com>
To: Rob Clark <robin.clark@oss.qualcomm.com>,
Dmitry Baryshkov <lumag@kernel.org>,
Abhinav Kumar <abhinav.kumar@linux.dev>,
Sean Paul <sean@poorly.run>,
Marijn Suijten <marijn.suijten@somainline.org>,
David Airlie <airlied@gmail.com>, Simona Vetter <simona@ffwll.ch>,
Jessica Zhang <jesszhan0024@gmail.com>,
Jessica Zhang <jesszhan0024@gmail.com>
Cc: linux-arm-msm@vger.kernel.org, dri-devel@lists.freedesktop.org,
freedreno@lists.freedesktop.org, linux-kernel@vger.kernel.org,
Yongxing Mou <yongxing.mou@oss.qualcomm.com>,
Abhinav Kumar <quic_abhinavk@quicinc.com>,
Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
Subject: [PATCH v6 11/29] drm/msm/dp: always program MST_FIFO_CONSTANT_FILL for MST use cases
Date: Mon, 31 Aug 2026 16:17:28 +0800 [thread overview]
Message-ID: <20260831-msm-dp-mst-v6-11-c91d35d6fb9e@oss.qualcomm.com> (raw)
In-Reply-To: <20260831-msm-dp-mst-v6-0-c91d35d6fb9e@oss.qualcomm.com>
From: Abhinav Kumar <quic_abhinavk@quicinc.com>
As per the hardware programming guide, MST_FIFO_CONSTANT_FILL must
always be programmed when operating in MST mode. Ensure the register
is configured accordingly.
Signed-off-by: Abhinav Kumar <quic_abhinavk@quicinc.com>
Signed-off-by: Yongxing Mou <yongxing.mou@oss.qualcomm.com>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
---
drivers/gpu/drm/msm/dp/dp_ctrl.c | 2 ++
drivers/gpu/drm/msm/dp/dp_panel.c | 12 ++++++++++++
drivers/gpu/drm/msm/dp/dp_panel.h | 2 ++
3 files changed, 16 insertions(+)
diff --git a/drivers/gpu/drm/msm/dp/dp_ctrl.c b/drivers/gpu/drm/msm/dp/dp_ctrl.c
index 77506e840883..9a0c9737e6d0 100644
--- a/drivers/gpu/drm/msm/dp/dp_ctrl.c
+++ b/drivers/gpu/drm/msm/dp/dp_ctrl.c
@@ -584,6 +584,8 @@ static void msm_dp_ctrl_configure_source_params(struct msm_dp_ctrl_private *ctrl
msm_dp_ctrl_config_misc1_misc0(ctrl, panel);
msm_dp_panel_timing_cfg(panel, ctrl->msm_dp_ctrl.wide_bus_en);
+
+ msm_dp_panel_mst_async_fifo(panel, ctrl->mst_active);
}
/*
diff --git a/drivers/gpu/drm/msm/dp/dp_panel.c b/drivers/gpu/drm/msm/dp/dp_panel.c
index d3468b73fdc3..bc7bad5ca3b1 100644
--- a/drivers/gpu/drm/msm/dp/dp_panel.c
+++ b/drivers/gpu/drm/msm/dp/dp_panel.c
@@ -741,6 +741,18 @@ int msm_dp_panel_timing_cfg(struct msm_dp_panel *msm_dp_panel, bool wide_bus_en)
return 0;
}
+void msm_dp_panel_mst_async_fifo(struct msm_dp_panel *msm_dp_panel, bool mst_en)
+{
+ struct msm_dp_panel_private *panel;
+
+ panel = container_of(msm_dp_panel, struct msm_dp_panel_private, msm_dp_panel);
+
+ if (mst_en)
+ msm_dp_write_pn(panel, MMSS_DP_ASYNC_FIFO_CONFIG, 0x01);
+ else
+ msm_dp_write_pn(panel, MMSS_DP_ASYNC_FIFO_CONFIG, 0x00);
+}
+
int msm_dp_panel_init_panel_info(struct msm_dp_panel *msm_dp_panel,
const struct drm_display_mode *adjusted_mode,
u32 bpp)
diff --git a/drivers/gpu/drm/msm/dp/dp_panel.h b/drivers/gpu/drm/msm/dp/dp_panel.h
index dc046fec24fc..04938b9d2091 100644
--- a/drivers/gpu/drm/msm/dp/dp_panel.h
+++ b/drivers/gpu/drm/msm/dp/dp_panel.h
@@ -72,6 +72,8 @@ void msm_dp_panel_clear_dsc_dto(struct msm_dp_panel *msm_dp_panel);
void msm_dp_panel_enable_vsc_sdp(struct msm_dp_panel *msm_dp_panel, struct dp_sdp *vsc_sdp);
void msm_dp_panel_disable_vsc_sdp(struct msm_dp_panel *msm_dp_panel);
+void msm_dp_panel_mst_async_fifo(struct msm_dp_panel *msm_dp_panel, bool mst_en);
+
/**
* is_link_rate_valid() - validates the link rate
* @bw_code: link rate requested by the sink
--
2.43.0
next prev parent reply other threads:[~2026-08-31 8:18 UTC|newest]
Thread overview: 34+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-08-31 8:17 [PATCH v6 00/29] drm/msm/dp: Add MST support for MSM chipsets Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 01/29] drm/msm/dp: move link-level teardown from display_disable to display_unprepare Yongxing Mou
2026-09-17 7:57 ` Dmitry Baryshkov
2026-08-31 8:17 ` [PATCH v6 02/29] drm/msm/dp: refactor msm_dp_ctrl_config_msa() to take panel Yongxing Mou
2026-09-17 7:56 ` Dmitry Baryshkov
2026-08-31 8:17 ` [PATCH v6 03/29] drm/msm/dp: drop redundant config_ctrl_link() from msm_dp_ctrl_on_stream() Yongxing Mou
2026-09-17 7:57 ` Dmitry Baryshkov
2026-08-31 8:17 ` [PATCH v6 04/29] drm/msm/dp: introduce stream_id for each DP panel Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 05/29] drm/msm/dp: add support for programming p1/p2/p3 register blocks Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 06/29] drm/msm/dp: add MST stream register definitions Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 07/29] drm/msm/dp: add stream-aware link register accessors Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 08/29] drm/msm/dp: add support to send ACT packets for MST Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 09/29] drm/msm/dp: add support to enable MST in mainlink control Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 10/29] drm/msm/dp: no need to update tu calculation for mst Yongxing Mou
2026-08-31 8:17 ` Yongxing Mou [this message]
2026-08-31 8:17 ` [PATCH v6 12/29] drm/msm/dp: add support for sending VCPF packets in DP controller Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 13/29] drm/msm/dp: add support for MST channel slot allocation Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 14/29] drm/msm/dp: replace power_on with active_stream_cnt Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 15/29] drm/msm/dp: factor out _helper variants of bridge ops accepting a panel Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 16/29] drm/msm/dp: add link_ready to manage link-level operations Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 17/29] drm/msm/dp: add msm_dp_display_get_panel() to initialize DP panel Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 18/29] drm/msm/dp: introduce dp_mst_drm module Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 19/29] drm/msm/dp: add MST connector creation and topology callbacks Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 20/29] drm/msm/dpu: pass msm_display_info to dpu_encoder_get_intf() Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 21/29] drm/msm/dpu: use stream_id to select MST interfaces Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 22/29] drm/msm/dpu: add per-stream MST encoders Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 23/29] drm/msm/dp: add atomic stream handling for MST Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 24/29] drm/msm/dp: add HPD callback for dp MST Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 25/29] drm/msm/dp: wire MST helpers into atomic check and commit paths Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 26/29] drm/msm/dp: mark the SST bridge disconnected when mst is active Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 27/29] drm/msm/dp: enable MST on capable sinks Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 28/29] drm/msm/dp: mark the SST bridge disconnected when an MST-capable sink is present Yongxing Mou
2026-08-31 8:17 ` [PATCH v6 29/29] drm/msm/dp: mark the SST connector disconnected when MST is enabled Yongxing Mou
2026-09-16 6:41 ` [PATCH v6 00/29] drm/msm/dp: Add MST support for MSM chipsets Yongxing Mou
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260831-msm-dp-mst-v6-11-c91d35d6fb9e@oss.qualcomm.com \
--to=yongxing.mou@oss.qualcomm.com \
--cc=abhinav.kumar@linux.dev \
--cc=airlied@gmail.com \
--cc=dmitry.baryshkov@oss.qualcomm.com \
--cc=dri-devel@lists.freedesktop.org \
--cc=freedreno@lists.freedesktop.org \
--cc=jesszhan0024@gmail.com \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=lumag@kernel.org \
--cc=marijn.suijten@somainline.org \
--cc=quic_abhinavk@quicinc.com \
--cc=robin.clark@oss.qualcomm.com \
--cc=sean@poorly.run \
--cc=simona@ffwll.ch \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®