[PATCH v2 1/3] remoteproc: qcom_q6v5_pas: propagate dev_pm_genpd_set_performance_state() errors

[Mukesh Ojha <mukesh.ojha@oss.qualcomm.com>]

The proxy power domain enable path discards the return value of
dev_pm_genpd_set_performance_state(), masking failures silently.
When the call fails the performance state is not applied, yet
firmware load proceeds without any indication of the problem.

Capture the return value and emit a warning on failure. Firmware
load continues regardless a performance state failure is non-fatal
but the warning provides a visible signal for debugging.

Signed-off-by: Mukesh Ojha <mukesh.ojha@oss.qualcomm.com>
---
 drivers/remoteproc/qcom_q6v5_pas.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/remoteproc/qcom_q6v5_pas.c b/drivers/remoteproc/qcom_q6v5_pas.c
index a005546c265d..01dc0194e130 100644
--- a/drivers/remoteproc/qcom_q6v5_pas.c
+++ b/drivers/remoteproc/qcom_q6v5_pas.c
@@ -167,7 +167,11 @@ static int qcom_pas_pds_enable(struct qcom_pas *pas, struct device **pds,
 	int i;
 
 	for (i = 0; i < pd_count; i++) {
-		dev_pm_genpd_set_performance_state(pds[i], INT_MAX);
+		ret = dev_pm_genpd_set_performance_state(pds[i], INT_MAX);
+		if (ret)
+			dev_warn(pas->dev,
+				 "failed to set proxy PD %d state %u: %d\n",
+				 i, INT_MAX, ret);
 		ret = pm_runtime_get_sync(pds[i]);
 		if (ret < 0) {
 			pm_runtime_put_noidle(pds[i]);
-- 
2.55.0