[PATCH v4 0/2] Add support for AS7343 multi-spectral sensor

[Chang Yu <marcus.yu.56@gmail.com>]

This series adds initial support for the AMS AS7343 14-channel
multi-spectral sensor.

The sensor has 14 optical channels (11 visible + NIR + clear +
flicker) in total. This initial driver supports reading raw counts
from all 12 spectral channels (11 visible + NIR) via sysfs and basic
power management.

Not yet supported:
- Configurable integration time and gain
- Interrupt support
- Clear (VIS) channel and flicker detection

Patch 1 adds device tree bindings.
Patch 2 adds the driver.

Testing was performed on a Raspberry Pi 4.

Datasheet: https://look.ams-osram.com/m/5f2d27fff9a874d2/original/AS7343-14-Channel-Multi-Spectral-Sensor.pdf

Changes in v4:
  - Fix led-max-microamp property in dt bindings.
  - Use REGCACHE_MAPLE and add volatile table.
  - Use PM_RUNTIME_ACQUIRE* when resuming.

Changes in v3:
  - Fix gpio description and example in dt.
  - Only start measurements after suspend action has been registered.
  - Add a mutex and pm_runtime_resume_and_get before reading measurements.

Changes in v2:
  - Add the LDR, the interrupt pin, and the GPIO pin to the dt bindings.
  - Adjust the default gain to x256 and integration time to 50.1ms as
  recommended by the datasheet.
  - Use read_label instead of .extend
  - Remove all unused scan_index related constants.

Chang Yu (2):
  dt-bindings: iio: light: add as7343
  iio: light: add AS7343 multi-spectral sensor driver

 .../bindings/iio/light/ams,as7343.yaml        |  72 +++
 MAINTAINERS                                   |   7 +
 drivers/iio/light/Kconfig                     |  11 +
 drivers/iio/light/Makefile                    |   1 +
 drivers/iio/light/as7343.c                    | 434 ++++++++++++++++++
 5 files changed, 525 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/iio/light/ams,as7343.yaml
 create mode 100644 drivers/iio/light/as7343.c

-- 
2.55.0