[PATCH v5 3/3] drm/rockchip: dsi: Relax the lane rate margin requirements

[Chaoyi Chen <kernel@airkyi.com>]

From: Chaoyi Chen <chaoyi.chen@rock-chips.com>

The lane rate is calculated as follows:

	Lane_Rate = Pixel_Clk * (BPP / lanes) * Overhead

The overhead factor is set to 1/0.8, equivalent to a 25% overhead.

Now let's consider the case of RGB888 (BPP24) with a pclk of 148.5MHz.
The lane rate equals 148.5M * (24 / 4) * 1.25 = 1113.75 Mbps.

However, this is beyond the capability of certain platforms limited to a
1Gbps lane rate. On the other hand, we have observed that some DSI panel
actually perform worse with higher overhead.

So we are considering relaxing the bandwidth margin requirements.
According to the downstream test results, adopting 1/0.9 seems to
be a sound approach, corresponding to an overhead of about 11%.

Signed-off-by: Chaoyi Chen <chaoyi.chen@rock-chips.com>
---
(no changes since v5)

Changes in v4:
- Fix potential overflow and underflow issues in bandwidth
  calculation(sashiko).

Changes in v3:
- Rebase to Linux v7.2
---
 drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
index feb484f7c03e..03019b99abdc 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi-rockchip.c
@@ -590,8 +590,8 @@ dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
 
 	mpclk = DIV_ROUND_UP(mode->clock, MSEC_PER_SEC);
 	if (mpclk) {
-		/* take 1 / 0.8, since mbps must big than bandwidth of RGB */
-		tmp = mpclk * (bpp / lanes) * 10 / 8;
+		/* take 1 / 0.9, since mbps must big than bandwidth of RGB */
+		tmp = DIV_ROUND_UP(mpclk * bpp * 10, lanes * 9);
 		if (tmp <= max_mbps)
 			target_mbps = tmp;
 		else
@@ -601,7 +601,7 @@ dw_mipi_dsi_get_lane_mbps(void *priv_data, const struct drm_display_mode *mode,
 
 	/* for external phy only a the mipi_dphy_config is necessary */
 	if (dsi->phy) {
-		phy_mipi_dphy_get_default_config(mode->clock * 1000 * 10 / 8,
+		phy_mipi_dphy_get_default_config((u32)mode->clock * 1000 * 10 / 9,
 						 bpp, lanes,
 						 &dsi->phy_opts.mipi_dphy);
 		dsi->lane_mbps = target_mbps;
-- 
2.53.0