[PATCH] pinctrl: qcom: lpass-lpi: Include value in debugfs output

[Bjorn Andersson <bjorn.andersson@oss.qualcomm.com>]

As with other pinctrl providers, it's useful to be able to inspect the
current GPIO state of the LPASS LPI pins during system integration and
debugging.

Extend the driver's debugfs logic to read the current value and include
this in the printout.

Signed-off-by: Bjorn Andersson <bjorn.andersson@oss.qualcomm.com>
---
 drivers/pinctrl/qcom/pinctrl-lpass-lpi.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c b/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c
index 5fd4a4eba654..9412fd36a4aa 100644
--- a/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c
+++ b/drivers/pinctrl/qcom/pinctrl-lpass-lpi.c
@@ -421,6 +421,7 @@ static void lpi_gpio_dbg_show_one(struct seq_file *s,
 	struct pinctrl_pin_desc pindesc;
 	unsigned int func;
 	int is_out;
+	int value;
 	int drive;
 	int pull;
 	u32 ctl_reg;
@@ -443,7 +444,10 @@ static void lpi_gpio_dbg_show_one(struct seq_file *s,
 	drive = FIELD_GET(LPI_GPIO_OUT_STRENGTH_MASK, ctl_reg);
 	pull = FIELD_GET(LPI_GPIO_PULL_MASK, ctl_reg);
 
-	seq_printf(s, " %-8s: %-3s %d", pindesc.name, is_out ? "out" : "in", func);
+	value = lpi_gpio_get(chip, offset);
+
+	seq_printf(s, " %-8s: %-3s", pindesc.name, is_out ? "out" : "in");
+	seq_printf(s, " %-4s func%d", str_high_low(value), func);
 	seq_printf(s, " %dmA", lpi_regval_to_drive(drive));
 	seq_printf(s, " %s", pulls[pull]);
 }

---
base-commit: 68142f986ff04b2b70b31db00f719bf690f64a9a
change-id: 20260915-pinctrl-lpass-debug-7aa2a92f0225

Best regards,
--  
Bjorn Andersson <bjorn.andersson@oss.qualcomm.com>