[PATCH v2 06/18] arm64: dts: qcom: sm8250: Fix PCIe WAKE# GPIO polarity

[Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>]

The PCIe WAKE# signal is active-low as defined in the PCIe Base
Specification. Fix the wake-gpios polarity by using GPIO_ACTIVE_LOW
instead of GPIO_ACTIVE_HIGH.

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
Reviewed-by: Manivannan Sadhasivam <mani@kernel.org>
Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/sm8250.dtsi | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sm8250.dtsi b/arch/arm64/boot/dts/qcom/sm8250.dtsi
index 90f8b091634e..e0c357222bc7 100644
--- a/arch/arm64/boot/dts/qcom/sm8250.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8250.dtsi
@@ -2211,7 +2211,7 @@ pcie0: pcie@1c00000 {
 			phy-names = "pciephy";
 
 			perst-gpios = <&tlmm 79 GPIO_ACTIVE_LOW>;
-			wake-gpios = <&tlmm 81 GPIO_ACTIVE_HIGH>;
+			wake-gpios = <&tlmm 81 GPIO_ACTIVE_LOW>;
 
 			pinctrl-names = "default";
 			pinctrl-0 = <&pcie0_default_state>;
@@ -2338,7 +2338,7 @@ pcie1: pcie@1c08000 {
 			phy-names = "pciephy";
 
 			perst-gpios = <&tlmm 82 GPIO_ACTIVE_LOW>;
-			wake-gpios = <&tlmm 84 GPIO_ACTIVE_HIGH>;
+			wake-gpios = <&tlmm 84 GPIO_ACTIVE_LOW>;
 
 			pinctrl-names = "default";
 			pinctrl-0 = <&pcie1_default_state>;
@@ -2465,7 +2465,7 @@ pcie2: pcie@1c10000 {
 			phy-names = "pciephy";
 
 			perst-gpios = <&tlmm 85 GPIO_ACTIVE_LOW>;
-			wake-gpios = <&tlmm 87 GPIO_ACTIVE_HIGH>;
+			wake-gpios = <&tlmm 87 GPIO_ACTIVE_LOW>;
 
 			pinctrl-names = "default";
 			pinctrl-0 = <&pcie2_default_state>;

-- 
2.34.1