[net-next,PATCH v1] enetc: Increase eMDIO MDC rate to 1.2 MHz

[Marek Vasut <marex@nabladev.com>]

The current eMDIO MDC rate is 558 kHz on i.MX95 B0. This is very low,
but also very compatible. However, for example NXP TJA1120 PHY needs
at minimum 1 MHz MDC clock and 558 kHz does not work with that PHY.

As a minimum change, increase the MDC clock to 1.2 MHz which should be
equally very compatible, since even old PHYs like LAN8210Ai, KSZ8794,
DP83822 support up to 2.5 MHz MDC clock frequency, and it covers the
NXP TJA1120 as well. There is no known rationale for why the 558 kHz
was picked when the eMDIO driver was added.

Signed-off-by: Marek Vasut <marex@nabladev.com>
---
Cc: "David S. Miller" <davem@davemloft.net>
Cc: Andrew Lunn <andrew+netdev@lunn.ch>
Cc: Clark Wang <xiaoning.wang@nxp.com>
Cc: Claudiu Manoil <claudiu.manoil@nxp.com>
Cc: Eric Dumazet <edumazet@google.com>
Cc: Jakub Kicinski <kuba@kernel.org>
Cc: Paolo Abeni <pabeni@redhat.com>
Cc: Vladimir Oltean <vladimir.oltean@nxp.com>
Cc: Wei Fang <wei.fang@nxp.com>
Cc: imx@lists.linux.dev
Cc: linux-kernel@vger.kernel.org
Cc: netdev@vger.kernel.org
---
NOTE: Alternatively, I can either add a DT property to configure the
      clock rate, or model the clock as clock hw divider and then use
      assigned-clock-rates DT property to configure the desired rate?
---
 drivers/net/ethernet/freescale/enetc/enetc_mdio.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/freescale/enetc/enetc_mdio.c b/drivers/net/ethernet/freescale/enetc/enetc_mdio.c
index 998aaa394e9c4..30ea91cea00e5 100644
--- a/drivers/net/ethernet/freescale/enetc/enetc_mdio.c
+++ b/drivers/net/ethernet/freescale/enetc/enetc_mdio.c
@@ -24,7 +24,7 @@
 
 #define ENETC_EMDIO_CFG \
 	(MDIO_CFG_HOLD(2) | \
-	 MDIO_CFG_CLKDIV(258) | \
+	 MDIO_CFG_CLKDIV(138) | \
 	 MDIO_CFG_NEG)
 
 #define MDIO_CTL_DEV_ADDR(x)	((x) & 0x1f)
-- 
2.53.0