Re: [PATCH] ACPI: GED: Support GpioInt event resources

[Mika Westerberg <mika.westerberg@linux.intel.com>]

Hi,

On Wed, Sep 30, 2026 at 10:22:22PM +0200, Linus Walleij wrote:
> On Wed, Sep 30, 2026 at 1:16 PM Rahul Pon <theflyingrahul@gmail.com> wrote:
> 
> > The Generic Event Device accepts only Interrupt and ExtendedInterrupt
> > resources in _CRS. Some ACPI firmware signals GED events through GPIO
> > controllers instead: the HP OmniBook 5 16-bf1xxx (Snapdragon X2) describes
> > its lid (LIGE) and embedded-controller event device (ECGE) as ACPI0013 with
> > GpioInt resources, and both currently fail to probe with "unable to parse
> > IRQ resource".
> >
> > Handle GpioInt resources: get the Linux IRQ with acpi_dev_gpio_irq_get(),
> > which applies the trigger and polarity and returns -EPROBE_DEFER until the
> > GPIO controller is registered, and evaluate _EVT with the GPIO pin number,
> > as done for GSIs above 255. GpioIo resources are skipped. On a failed walk,
> > free the events already requested and propagate the GPIO error (including
> > -EPROBE_DEFER) instead of -EINVAL.
> >
> > Tested on the HP OmniBook 5 16-bf1xxx: lid close/open run _EVT and reach
> > the ACPI button driver and logind.
> >
> > Assisted-by: LLM
> > Signed-off-by: Rahul Pon <theflyingrahul@gmail.com>
> 
> I don't understand the patch at all, but I understand that Andy or Mika must
> review it otherwise it's not going anywhere, so looping them in.

ACPI GED specifically is supposed to use interrupts only (hence the name,
Interrupt -signaled ACPI events). I think this one should really use the
GPIO signaled ACPI events instead and probably just has the ACPI0013 there
by accident. Can you share the ASL around this device?