[PATCH net-next v3 4/6] net: ftgmac100: Require phy-mode for AST2700

[Jacky Chou <jacky_chou@aspeedtech.com>]

The driver currently defaults to RGMII when the "phy-mode" property
is missing from the device tree. This default is no longer valid for
AST2700, which also supports RMII via FTGMAC100_QUIRK_RMII_ENABLE.

Make "phy-mode" a required property for AST2700 and fail probe with
an error message if it is not specified, instead of silently
defaulting to RGMII.

Signed-off-by: Jacky Chou <jacky_chou@aspeedtech.com>
---
 drivers/net/ethernet/faraday/ftgmac100.c | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/faraday/ftgmac100.c b/drivers/net/ethernet/faraday/ftgmac100.c
index 9b7becb01726..5a578a62df67 100644
--- a/drivers/net/ethernet/faraday/ftgmac100.c
+++ b/drivers/net/ethernet/faraday/ftgmac100.c
@@ -1526,8 +1526,13 @@ static int ftgmac100_mii_probe(struct net_device *netdev)
 
 	/* Default to RGMII. It's a gigabit part after all */
 	err = of_get_phy_mode(np, &phy_intf);
-	if (err)
+	if (err) {
+		if (priv->mac_id == FTGMAC100_AST2700) {
+			dev_err(priv->dev, "phy-mode is required for this SoC\n");
+			return -EINVAL;
+		}
 		phy_intf = PHY_INTERFACE_MODE_RGMII;
+	}
 
 	/* Aspeed only supports these. I don't know about other IP
 	 * block vendors so I'm going to just let them through for

-- 
2.34.1