[PATCH v11 0/3] arm: dts: altera: add Draeger M48 CPU board

[Petko Manolov <petko.manolov@konsulko.com>]

Adding the device trees for “Dräger M48 on NXP i.MX6 (Q) and Intel/Altera
SoCFPGA Cyclone V” board variant.  It has both (the SoC and FPGA) on the
same carrier and they are cross-monitoring each other.  The SoCFPGA boots
independently off qspi flash.

This is the SoCFPGA devicetree part.

in v11:

  - replace the ethphy compatible string;

and in v10:

  - add device_type back to the memory node;
  - move the compatible string under the phy node;

news for v9:

  - remove the name property from the memory node;
  - fix a typo in a comment;
  - attached phy-specific skew properties to dedicated mdio phy sub-node;
  - add Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@oss.qualcomm.com>

now in v8:

  - modified draeger,m48 to draeger,socfpga-48 because it is more consistent;
    with its other imx counterparts imx6q-m48 and imx6dl-m48;
  - dropped gpio3 and gpio4 bindings;

new in v7:

  - replaced module with board as this seems to be confusing to some;
  - add Acked-by: Conor Dooley <conor.dooley@microchip.com> tag;

Petko Manolov (3):
  dt-bindings: vendor-prefixes: add Draeger AG
  dt-bindings: arm: altera: add Draeger M48 dual-cpu board
  arm: dts: altera: add Draeger M48 CPU Module

 .../devicetree/bindings/arm/altera.yaml       |   1 +
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm/boot/dts/intel/socfpga/Makefile      |   1 +
 .../socfpga/socfpga_cyclone5_draeger_m48.dts  | 101 ++++++++++++++++++
 4 files changed, 105 insertions(+)
 create mode 100644 arch/arm/boot/dts/intel/socfpga/socfpga_cyclone5_draeger_m48.dts

-- 
2.47.3