[PATCH v2 5/6] mtd: rawnand: marvell: stop DMA before unmapping on timeout

[Samarth Narang <samarth.colleges@gmail.com>]

When marvell_nfc_wait_cmdd() times out in marvell_nfc_xfer_data_dma(),
the driver unmaps the DMA buffer before calling
dmaengine_terminate_all(), which does not guarantee that the transfer
has stopped. As a result, the DMA engine may continue accessing the
buffer after its mapping has been released.

Use dmaengine_terminate_sync() before unmapping the buffer on the
timeout path, while preserving the existing status logging before
termination so that it reflects the timed-out transfer.

Fixes: 02f26ecf8c77 ("mtd: nand: add reworked Marvell NAND controller driver")
Assisted-by: LLM
Signed-off-by: Samarth Narang <samarth.colleges@gmail.com>
---
This issue was identified by a research static analyzer for DMA
lifecycle ordering and has not been validated on hardware.

 drivers/mtd/nand/raw/marvell_nand.c | 9 +++++----
 1 file changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/mtd/nand/raw/marvell_nand.c b/drivers/mtd/nand/raw/marvell_nand.c
index 38b7eb5b9..a342a48e2 100644
--- a/drivers/mtd/nand/raw/marvell_nand.c
+++ b/drivers/mtd/nand/raw/marvell_nand.c
@@ -900,14 +900,15 @@ static int marvell_nfc_xfer_data_dma(struct marvell_nfc *nfc,
 
 	dma_async_issue_pending(nfc->dma_chan);
 	ret = marvell_nfc_wait_cmdd(nfc->selected_chip);
-	dma_unmap_sg(nfc->dma_chan->device->dev, &sg, 1, direction);
-	marvell_nfc_disable_dma(nfc);
 	if (ret) {
 		dev_err(nfc->dev, "Timeout waiting for DMA (status: %d)\n",
 			dmaengine_tx_status(nfc->dma_chan, cookie, NULL));
-		dmaengine_terminate_all(nfc->dma_chan);
-		return -ETIMEDOUT;
+		dmaengine_terminate_sync(nfc->dma_chan);
 	}
+	dma_unmap_sg(nfc->dma_chan->device->dev, &sg, 1, direction);
+	marvell_nfc_disable_dma(nfc);
+	if (ret)
+		return -ETIMEDOUT;
 
 	return 0;
 }
-- 
2.34.1