[PATCH 5/6] arm64: dts: allwinner: a133: Add CPU OPP table

[Rajan Yadav via B4 Relay <devnull+rajanyadav0307.gmail.com@kernel.org>]

From: Rajan Yadav <rajanyadav0307@gmail.com>

Add the A133 CPU OPPs from the vendor BSP (sun50iw10p1.dtsi). There
are ten voltage sets, speed0-5 for the a0-a5/a6 grades and speed6-9
for the "high speed" b0-b3 grades. opp-supported-hw selects the
frequencies of each grade:

- 1464 MHz only for the a grades
- 1416 and 1512 MHz only for the b grades
- 408-1320 MHz for all

The highest voltage is 1.18 V, inside the 0.81-1.2 V recommended
operating range of VDD_CPU in the A133 datasheet (V1.5, table 5-2).

The BSP uses 1008 MHz where the A100 table uses 1080 MHz, at the same
voltages for a0-a2. U-Boot starts the CPU at 1008 MHz, which mainline
now reports as an unlisted initial frequency. This table follows the
BSP. The BSP table stops at 1512 MHz, so there is no 1608 MHz OPP,
although some datasheet versions list 1.6 GHz for the A133. A newer
factory kernel adds 1608 MHz for b0 and b1 only; that is left for a
follow-up.

The table has the A100 compatible as a fallback and the speed bin cell
first, so a kernel without A133 support selects speed0-2 from the speed
bin and gets the voltages of the A100 table, with 1008 instead of
1080 MHz. It needs the efuse cells added to sun50i-a100.dtsi in the
previous patch.

A script compared every voltage and the frequency set of every grade
with the BSP file and found no difference.

Claude Code (Anthropic) drafted this table and its message from the
vendor BSP device tree (numbers only) and wrote the comparison script;
I reviewed it and tested it on a KickPi K5C.

Suggested-by: Andre Przywara <andre.przywara@arm.com>
Signed-off-by: Rajan Yadav <rajanyadav0307@gmail.com>
---
 .../boot/dts/allwinner/sun50i-a133-cpu-opp.dtsi    | 172 +++++++++++++++++++++
 1 file changed, 172 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a133-cpu-opp.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-a133-cpu-opp.dtsi
new file mode 100644
index 00000000000..12b6612a920
--- /dev/null
+++ b/arch/arm64/boot/dts/allwinner/sun50i-a133-cpu-opp.dtsi
@@ -0,0 +1,172 @@
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+// Copyright (C) 2026 Rajan Yadav <rajanyadav0307@gmail.com>
+/*
+ * A133 CPU OPPs. The voltages and grade selection follow the Allwinner
+ * vendor BSP (sun50iw10p1.dtsi). Index 0-5 are the vendor's a0-a5 grades
+ * (a6 uses the a5 values), index 6-9 are the "high speed" b0-b3 grades.
+ * This needs the efuse cells from sun50i-a100.dtsi.
+ */
+
+/ {
+	cpu_opp_table: opp-table-cpu {
+		compatible = "allwinner,sun50i-a133-operating-points",
+			     "allwinner,sun50i-a100-operating-points";
+		nvmem-cells = <&cpu_speed_grade>, <&chip_marking>,
+			      <&cpu_pcpu>, <&cpu_bin_ext>;
+		nvmem-cell-names = "bin", "marking", "pcpu", "bin-ext";
+		opp-shared;
+
+		opp-408000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <408000000>;
+
+			opp-microvolt-speed0 = <900000>;
+			opp-microvolt-speed1 = <900000>;
+			opp-microvolt-speed2 = <900000>;
+			opp-microvolt-speed3 = <940000>;
+			opp-microvolt-speed4 = <940000>;
+			opp-microvolt-speed5 = <920000>;
+			opp-microvolt-speed6 = <900000>;
+			opp-microvolt-speed7 = <900000>;
+			opp-microvolt-speed8 = <940000>;
+			opp-microvolt-speed9 = <920000>;
+			opp-supported-hw = <0x3ff>;
+		};
+
+		opp-600000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <600000000>;
+
+			opp-microvolt-speed0 = <900000>;
+			opp-microvolt-speed1 = <900000>;
+			opp-microvolt-speed2 = <900000>;
+			opp-microvolt-speed3 = <940000>;
+			opp-microvolt-speed4 = <940000>;
+			opp-microvolt-speed5 = <920000>;
+			opp-microvolt-speed6 = <900000>;
+			opp-microvolt-speed7 = <900000>;
+			opp-microvolt-speed8 = <940000>;
+			opp-microvolt-speed9 = <920000>;
+			opp-supported-hw = <0x3ff>;
+		};
+
+		opp-816000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <816000000>;
+
+			opp-microvolt-speed0 = <940000>;
+			opp-microvolt-speed1 = <900000>;
+			opp-microvolt-speed2 = <900000>;
+			opp-microvolt-speed3 = <940000>;
+			opp-microvolt-speed4 = <940000>;
+			opp-microvolt-speed5 = <920000>;
+			opp-microvolt-speed6 = <900000>;
+			opp-microvolt-speed7 = <900000>;
+			opp-microvolt-speed8 = <940000>;
+			opp-microvolt-speed9 = <920000>;
+			opp-supported-hw = <0x3ff>;
+		};
+
+		opp-1008000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <1008000000>;
+
+			opp-microvolt-speed0 = <1020000>;
+			opp-microvolt-speed1 = <980000>;
+			opp-microvolt-speed2 = <950000>;
+			opp-microvolt-speed3 = <1020000>;
+			opp-microvolt-speed4 = <960000>;
+			opp-microvolt-speed5 = <940000>;
+			opp-microvolt-speed6 = <980000>;
+			opp-microvolt-speed7 = <950000>;
+			opp-microvolt-speed8 = <960000>;
+			opp-microvolt-speed9 = <940000>;
+			opp-supported-hw = <0x3ff>;
+		};
+
+		opp-1200000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <1200000000>;
+
+			opp-microvolt-speed0 = <1100000>;
+			opp-microvolt-speed1 = <1020000>;
+			opp-microvolt-speed2 = <1000000>;
+			opp-microvolt-speed3 = <1100000>;
+			opp-microvolt-speed4 = <980000>;
+			opp-microvolt-speed5 = <960000>;
+			opp-microvolt-speed6 = <1020000>;
+			opp-microvolt-speed7 = <1000000>;
+			opp-microvolt-speed8 = <980000>;
+			opp-microvolt-speed9 = <960000>;
+			opp-supported-hw = <0x3ff>;
+		};
+
+		opp-1320000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <1320000000>;
+
+			opp-microvolt-speed0 = <1160000>;
+			opp-microvolt-speed1 = <1060000>;
+			opp-microvolt-speed2 = <1030000>;
+			opp-microvolt-speed3 = <1160000>;
+			opp-microvolt-speed4 = <1020000>;
+			opp-microvolt-speed5 = <1000000>;
+			opp-microvolt-speed6 = <1060000>;
+			opp-microvolt-speed7 = <1030000>;
+			opp-microvolt-speed8 = <1020000>;
+			opp-microvolt-speed9 = <1000000>;
+			opp-supported-hw = <0x3ff>;
+		};
+
+		opp-1416000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <1416000000>;
+
+			opp-microvolt-speed6 = <1100000>;
+			opp-microvolt-speed7 = <1070000>;
+			opp-microvolt-speed8 = <1060000>;
+			opp-microvolt-speed9 = <1040000>;
+			opp-supported-hw = <0x3c0>;
+		};
+
+		opp-1464000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <1464000000>;
+
+			opp-microvolt-speed0 = <1180000>;
+			opp-microvolt-speed1 = <1180000>;
+			opp-microvolt-speed2 = <1130000>;
+			opp-microvolt-speed3 = <1180000>;
+			opp-microvolt-speed4 = <1100000>;
+			opp-microvolt-speed5 = <1080000>;
+			opp-supported-hw = <0x3f>;
+		};
+
+		opp-1512000000 {
+			clock-latency-ns = <244144>; /* 8 32k periods */
+			opp-hz = /bits/ 64 <1512000000>;
+
+			opp-microvolt-speed6 = <1180000>;
+			opp-microvolt-speed7 = <1130000 1130000 1140000>;
+			opp-microvolt-speed8 = <1100000>;
+			opp-microvolt-speed9 = <1080000>;
+			opp-supported-hw = <0x3c0>;
+		};
+	};
+};
+
+&cpu0 {
+	operating-points-v2 = <&cpu_opp_table>;
+};
+
+&cpu1 {
+	operating-points-v2 = <&cpu_opp_table>;
+};
+
+&cpu2 {
+	operating-points-v2 = <&cpu_opp_table>;
+};
+
+&cpu3 {
+	operating-points-v2 = <&cpu_opp_table>;
+};

-- 
2.34.1