[PATCH 1/2] remoteproc: k3: Report a remote crash to the remoteproc core

[Chrispine Tinega <dev@chrispinetinega.com>]

A K3 remote core that faults can send RP_MBOX_CRASH over the mailbox,
but k3_rproc_mbox_callback() only logs it. The remoteproc core never
learns of the crash, so its recovery never runs, the crash is not
counted, and the core stays halted with every rpmsg channel to it dead.

Call rproc_report_crash(), which may be called from atomic context. The
core then moves to RPROC_CRASHED and the crash is counted. Where the
driver leaves recovery enabled, recovery stops the core and boots it
again. Where recovery is disabled, the core can still be stopped and
started again through sysfs.

Signed-off-by: Chrispine Tinega <dev@chrispinetinega.com>
---
 drivers/remoteproc/ti_k3_common.c | 5 +----
 1 file changed, 1 insertion(+), 4 deletions(-)

diff --git a/drivers/remoteproc/ti_k3_common.c b/drivers/remoteproc/ti_k3_common.c
index 4b6da3363..d799f377b 100644
--- a/drivers/remoteproc/ti_k3_common.c
+++ b/drivers/remoteproc/ti_k3_common.c
@@ -60,11 +60,8 @@ void k3_rproc_mbox_callback(struct mbox_client *client, void *data)
 
 	switch (msg) {
 	case RP_MBOX_CRASH:
-		/*
-		 * remoteproc detected an exception, but error recovery is not
-		 * supported. So, just log this for now
-		 */
 		dev_err(dev, "K3 rproc %s crashed\n", rproc->name);
+		rproc_report_crash(rproc, RPROC_FATAL_ERROR);
 		break;
 	case RP_MBOX_ECHO_REPLY:
 		dev_info(dev, "received echo reply from %s\n", rproc->name);
-- 
2.53.0