[PATCH] pinctrl: sunxi: a733: do not switch the mux to read IRQ lines

[Vinicius Pedrosa <vinicius.eduardo.pedrosa@gmail.com>]

The A733 description sets irq_read_needs_mux. When a GPIO used as an
interrupt is read, sunxi_pinctrl_gpio_get() then switches the pin to
input and back to SUN4I_FUNC_IRQ, which is function 6. The A733
interrupt function is 14, so after the first read the pin is left on
function 6 and its interrupt no longer fires.

On my board this breaks microSD card detection: the PF6
card-detect line is read at probe, and after that neither removal nor
insertion of the card is noticed.

The A733 data register reports the pin level while the pin is muxed
to the interrupt function, so the switch is not needed. The A523 and
D1 descriptions do not set this flag either. Drop it.

Fixes: 0535bfbfa97b ("pinctrl: sunxi: add support for the Allwinner A733")
Signed-off-by: Vinicius Pedrosa <vinicius.eduardo.pedrosa@gmail.com>
---
Tested on a Cubie A7Z with the pending A733 clock, PMIC and DT series
applied: before this change PF6 read back function 6 and card removal
and insertion were not seen; with it PF6 stays on function 14 and one
removal/insertion cycle was detected.

 drivers/pinctrl/sunxi/pinctrl-sun60i-a733.c | 1 -
 1 file changed, 1 deletion(-)

diff --git a/drivers/pinctrl/sunxi/pinctrl-sun60i-a733.c b/drivers/pinctrl/sunxi/pinctrl-sun60i-a733.c
index ca82f08a3a65..456d9170c2a2 100644
--- a/drivers/pinctrl/sunxi/pinctrl-sun60i-a733.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sun60i-a733.c
@@ -23,7 +23,6 @@ static const u8 a733_irq_bank_muxes[SUNXI_PINCTRL_MAX_BANKS] =
 
 static struct sunxi_pinctrl_desc a733_pinctrl_data = {
 	.irq_banks = 10,
-	.irq_read_needs_mux = true,
 	.io_bias_cfg_variant = BIAS_VOLTAGE_PIO_POW_MODE_SEL,
 };
 
-- 
2.43.0