From: Jesse Casco <jesse.casco@gmail.com>
To: Rahul Samana <rahul.samana@oss.qualcomm.com>
Cc: Bartosz Golaszewski <brgl@kernel.org>,
Marcel Holtmann <marcel@holtmann.org>,
Luiz Augusto von Dentz <luiz.dentz@gmail.com>,
Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
Balakrishna Godavarthi <quic_bgodavar@quicinc.com>,
Rocky Liao <quic_rjliao@quicinc.com>,
Manivannan Sadhasivam <mani@kernel.org>,
Bjorn Andersson <andersson@kernel.org>,
Konrad Dybcio <konradybcio@kernel.org>,
Bartosz Golaszewski <brgl@bgdev.pl>,
linux-arm-msm@vger.kernel.org, linux-bluetooth@vger.kernel.org,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-pci@vger.kernel.org, linux-pm@vger.kernel.org,
quic_mohamull@quicinc.com, quic_hbandi@quicinc.com,
quic_anubhavg@quicinc.com,
Vivek Sahu <vivek.sahu@oss.qualcomm.com>,
Yepuri Siddu <yepuri.siddu@oss.qualcomm.com>
Subject: Re: [PATCH v2 2/6] Bluetooth: qca: add QCC2072 support
Date: Tue, 10 Nov 2026 13:12:50 -0500 [thread overview]
Message-ID: <20261110181250.47751-1-jesse.casco@gmail.com> (raw)
In-Reply-To: <20260727-rb3-industrial-bt-uart-v2-2-2d100f30e202@oss.qualcomm.com>
Tested patches 1-3 on an ASUS Zenbook A16 (UX3607OA, X2 Elite), 7.4-rc1
based. The controller (product 0x20, ROM 0x0101, board ID 0x17) now
loads ornbtfw11.tlv, ornnv11.bin and ornbcscal11.bin instead of falling
back to ROM firmware, and a phone pairs and plays A2DP audio.
With the mainline A16 DT (M.2 E connector, no Bluetooth node), patch 3
creates the BT node, but the card only powers on with Manivannan's
"Bluetooth: hci_qca: Add M.2 Bluetooth device support using pwrseq" [1]
applied too. Without it, hci_qca asks for a "bluetooth" pwrseq target
the connector doesn't provide, W_DISABLE2# stays asserted and reading
the version times out (-110).
One of five boots failed: the rampatch download timed out
("command 0xfc00 tx timeout", "Failed to send TLV segment (-110)") and
the "Retry BT power ON" never completed, leaving BT down until
userspace powered it on. ath12k was bringing up WLAN on the same chip
during the download in every boot, so I suspect contention there.
[1] https://lore.kernel.org/r/20261005-monza-wireless-v7-1-5a6de7662dcb@oss.qualcomm.com
Tested-by: Jesse Casco <jesse.casco@gmail.com> # ASUS Zenbook A16 (UX3607OA)
next prev parent reply other threads:[~2026-11-10 18:12 UTC|newest]
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-07-27 15:45 [PATCH v2 0/6] Bluetooth: qca: enable QCC2072 on RB3 Gen 2 Industrial Rahul Samana
2026-07-27 15:45 ` [PATCH v2 1/6] dt-bindings: bluetooth: qca: add QCC2072 Rahul Samana
2026-07-31 9:46 ` Krzysztof Kozlowski
2026-07-31 14:45 ` Rahul Samana
2026-07-31 15:04 ` Krzysztof Kozlowski
2026-07-31 15:51 ` Rahul Samana
2026-08-01 14:48 ` Krzysztof Kozlowski
2026-08-01 15:31 ` Rahul Samana
2026-08-01 15:49 ` Krzysztof Kozlowski
2026-08-05 12:09 ` Manivannan Sadhasivam
2026-08-05 12:33 ` Krzysztof Kozlowski
2026-08-05 14:12 ` Manivannan Sadhasivam
2026-08-05 14:36 ` Krzysztof Kozlowski
2026-08-05 14:52 ` Manivannan Sadhasivam
2026-08-07 9:40 ` Dmitry Baryshkov
2026-08-10 10:28 ` Krzysztof Kozlowski
2026-08-07 9:57 ` Dmitry Baryshkov
2026-08-10 10:27 ` Krzysztof Kozlowski
2026-07-27 15:45 ` [PATCH v2 2/6] Bluetooth: qca: add QCC2072 support Rahul Samana
2026-07-31 15:09 ` Dmitry Baryshkov
2026-07-31 17:51 ` Rahul Samana
2026-11-10 18:12 ` Jesse Casco [this message]
2026-07-27 15:45 ` [PATCH v2 3/6] power: sequencing: pwrseq-pcie-m2: add QCC2072 Rahul Samana
2026-07-27 15:45 ` [PATCH v2 4/6] arm64: dts: qcom: qcs6490-rb3gen2: label BT PMU and M.2 PCI node Rahul Samana
2026-07-31 15:30 ` Rahul Samana
2026-07-27 15:45 ` [PATCH v2 5/6] arm64: dts: qcom: kodiak: mark PCIe root port as bridge Rahul Samana
2026-07-27 15:57 ` Rahul Samana
2026-07-29 12:29 ` Konrad Dybcio
2026-07-27 15:45 ` [PATCH v2 6/6] arm64: dts: qcom: rb3gen2: add Industrial BT UART overlay Rahul Samana
2026-07-29 12:31 ` Konrad Dybcio
2026-07-31 6:53 ` Rahul Samana
2026-07-31 12:50 ` Konrad Dybcio
2026-07-31 14:48 ` Rahul Samana
2026-07-31 15:49 ` Konrad Dybcio
2026-07-31 17:50 ` Rahul Samana
2026-08-02 3:38 ` Bjorn Andersson
2026-08-05 6:18 ` Rahul Samana
2026-08-06 23:02 ` Bjorn Andersson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261110181250.47751-1-jesse.casco@gmail.com \
--to=jesse.casco@gmail.com \
--cc=andersson@kernel.org \
--cc=brgl@bgdev.pl \
--cc=brgl@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=konradybcio@kernel.org \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-bluetooth@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pci@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=luiz.dentz@gmail.com \
--cc=mani@kernel.org \
--cc=marcel@holtmann.org \
--cc=quic_anubhavg@quicinc.com \
--cc=quic_bgodavar@quicinc.com \
--cc=quic_hbandi@quicinc.com \
--cc=quic_mohamull@quicinc.com \
--cc=quic_rjliao@quicinc.com \
--cc=rahul.samana@oss.qualcomm.com \
--cc=robh@kernel.org \
--cc=vivek.sahu@oss.qualcomm.com \
--cc=yepuri.siddu@oss.qualcomm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®