[PATCH net-next v3 1/2] dt-bindings: net: nfc: samsung,s3fwrn5: Add pvdd-supply

[Asdlerto Korry via B4 Relay <devnull+korryasdlerto.gmail.com@kernel.org>]

From: Asdlerto Korry <korryasdlerto@gmail.com>

The PVDD pin of the S3FWRN5 has to be powered before the chip is
enabled. On some boards, like the Samsung Galaxy M52 5G, this supply
is switched by a SoC GPIO. Document it, so that the regulator can be
handed to the driver instead of being kept always on.

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@oss.qualcomm.com>
Signed-off-by: Asdlerto Korry <korryasdlerto@gmail.com>
---
 Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml b/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml
index 12baee45752c..3c5a579a7108 100644
--- a/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml
+++ b/Documentation/devicetree/bindings/net/nfc/samsung,s3fwrn5.yaml
@@ -34,6 +34,10 @@ properties:
     description:
       Output GPIO pin used to enter firmware mode and sleep/wakeup control
 
+  pvdd-supply:
+    description:
+      Power supply of the PVDD pin
+
   s3fwrn5,en-gpios:
     maxItems: 1
     deprecated: true
@@ -84,6 +88,7 @@ examples:
             wake-gpios = <&gpj0 2 GPIO_ACTIVE_HIGH>;
 
             clocks = <&rpmcc 20>;
+            pvdd-supply = <&nfc_pvdd>;
         };
     };
   # UART example on Raspberry Pi

-- 
2.25.1