On Mon, Nov 16, 2026 at 06:48:51PM +0100, John Crispin wrote: > Document the AN7589 pin controller. It lives under the GPIO system > controller and selects functions through a separate IOMUX syscon, > referenced by the airoha,iomux phandle. Every pin is a GPIO in mode 0. > > The AN7589 has no chip SCU dependency and the vendor SDK carries no pull > or drive registers for it. Groups follow the SDK naming without its _grp > suffix. As in the other Airoha pin controller bindings, a function names > a block type, such as uart or i2c, and the group selects the instance. A > node selects one group, except for pcm_spi and pcie, whose groups carry > different signals of one device. The PON groups keep the working mode > only: the SDK encodes the driver reset sequence as extra pinctrl states, > which belongs in the consumer driver. > > The pwm function routes a PWM channel to one of GPIO0 to GPIO15, with > one group per pin. The pin also needs its GPIO output enabled, so conf > nodes allow the GPIO direction and output level. Pull and drive > properties are not allowed, as no registers for them are known. > > Signed-off-by: John Crispin > --- > Changes in v3: > - Move the IOMUX syscon compatible and the GPIO system controller to > patches of their own (Lee, Conor). > - Allow one group per node, except for pcm_spi and pcie, whose groups > carry different signals of one device (Conor). > - Fix the uart5 example, which listed uart5 and uart5_full together. As discussed elsewhere, pw-bot: changes-requested Thanks, Conor.