From: Arthur Korn <akorn@google.com>
To: Guenter Roeck <linux@roeck-us.net>
Cc: linux-hwmon@vger.kernel.org, linux-kernel@vger.kernel.org,
Arthur Korn <akorn@google.com>
Subject: [PATCH v2] hwmon: (pmbus) Clear only CML invalid command fault during probe
Date: Thu, 19 Nov 2026 01:32:08 +0000 [thread overview]
Message-ID: <20261119013208.4089480-1-akorn@google.com> (raw)
During driver initialization and register capability probing, pmbus_core
and the generic pmbus driver send CLEAR_FAULTS (0x03) to clear any
communication or command faults triggered while probing unsupported
registers. However, CLEAR_FAULTS unconditionally clears all latched
fault status bits across the device, including hardware power fault
registers such as STATUS_WORD, STATUS_VOUT, STATUS_IOUT, and
STATUS_MFR_SPECIFIC. As a result, a BMC reboot or driver re-probe erases
pre-existing voltage regulator fault telemetry before monitoring or
diagnostic tools can inspect it.
Simply omitting fault clearing during probe is not viable because
probing unsupported commands (such as PMBUS_PAGE on single-page PMBus
devices) asserts PB_CML_FAULT_INVALID_COMMAND in STATUS_CML. Leaving
that bit latched causes pmbus_check_status_cml() to fail subsequent
capability checks (including PMBUS_VOUT_MODE and sensor discovery) with
-EIO.
Starting with PMBus Revision 1.2, individual bits in STATUS_CML can be
cleared via Write-1-to-Clear (W1C), a mechanism pmbus_core already uses
in pmbus_get_boolean(). Introduce pmbus_clear_cml_fault() and export
pmbus_clear_cml_faults() in the "PMBUS" module namespace to write
PB_CML_FAULT_INVALID_COMMAND to PMBUS_STATUS_CML during device
initialization, register probing, and pmbus_identify() on PMBus 1.2+
devices while preserving all other latched fault bits. Fall back to
pmbus_clear_fault_page() on PMBus < 1.2 devices or if writing
PMBUS_STATUS_CML fails.
Tested on BMC hardware across 130 hwmon devices (105 PMBus devices
covering tda38740/xdpe1a2g5b, isl68137/raa228234, adm1266,
ltc4286/ltc4287, and generic pmbus regulators including TI
tps546e25/tps546b25 and factory write-protected converters), verifying
that all devices probe cleanly with no -EIO regressions. Also verified
via unbind, fault injection, and re-bind across both driver-specific and
generic pmbus_identify() paths that PB_CML_FAULT_INVALID_COMMAND in
PMBUS_STATUS_CML is cleared on probe while other STATUS_CML and
STATUS_WORD fault bits remain preserved, and verified clean fallback
when writing PMBUS_STATUS_CML is NACKed.
Signed-off-by: Arthur Korn <akorn@google.com>
---
Changes in v2:
- Fall back to pmbus_clear_fault_page() if writing PMBUS_STATUS_CML
fails (e.g. NACK on devices that do not support W1C on STATUS_CML).
- Export pmbus_clear_cml_faults() in the "PMBUS" namespace and use it in
pmbus_identify() (pmbus.c) so generic pmbus devices also preserve
non-CML faults during probe.
- Re-tested on hardware covering generic pmbus_identify() fault
preservation and the STATUS_CML write-failure fallback path.
drivers/hwmon/pmbus/pmbus.c | 2 +-
drivers/hwmon/pmbus/pmbus.h | 1 +
drivers/hwmon/pmbus/pmbus_core.c | 30 +++++++++++++++++++++++++-----
3 files changed, 27 insertions(+), 6 deletions(-)
diff --git a/drivers/hwmon/pmbus/pmbus.c b/drivers/hwmon/pmbus/pmbus.c
index f8189c11..f239dafb 100644
--- a/drivers/hwmon/pmbus/pmbus.c
+++ b/drivers/hwmon/pmbus/pmbus.c
@@ -113,7 +113,7 @@ static int pmbus_identify(struct i2c_client *client,
info->pages = 1;
}
- pmbus_clear_faults(client);
+ pmbus_clear_cml_faults(client);
}
if (pmbus_check_byte_register(client, 0, PMBUS_VOUT_MODE)) {
diff --git a/drivers/hwmon/pmbus/pmbus.h b/drivers/hwmon/pmbus/pmbus.h
index 5525c048..8170098f 100644
--- a/drivers/hwmon/pmbus/pmbus.h
+++ b/drivers/hwmon/pmbus/pmbus.h
@@ -581,6 +581,7 @@ int pmbus_write_byte_data(struct i2c_client *client, int page, u8 reg,
int pmbus_update_byte_data(struct i2c_client *client, int page, u8 reg,
u8 mask, u8 value);
void pmbus_clear_faults(struct i2c_client *client);
+void pmbus_clear_cml_faults(struct i2c_client *client);
void pmbus_check_and_notify_faults(struct i2c_client *client);
bool pmbus_check_byte_register(struct i2c_client *client, int page, int reg);
bool pmbus_check_word_register(struct i2c_client *client, int page, int reg);
diff --git a/drivers/hwmon/pmbus/pmbus_core.c b/drivers/hwmon/pmbus/pmbus_core.c
index b3aa7f1a..a5255ffb 100644
--- a/drivers/hwmon/pmbus/pmbus_core.c
+++ b/drivers/hwmon/pmbus/pmbus_core.c
@@ -717,6 +717,26 @@ void pmbus_clear_faults(struct i2c_client *client)
}
EXPORT_SYMBOL_NS_GPL(pmbus_clear_faults, "PMBUS");
+static void pmbus_clear_cml_fault(struct i2c_client *client, int page)
+{
+ struct pmbus_data *data = i2c_get_clientdata(client);
+
+ if (data->revision < PMBUS_REV_12 ||
+ _pmbus_write_byte_data(client, page, PMBUS_STATUS_CML,
+ PB_CML_FAULT_INVALID_COMMAND) < 0)
+ pmbus_clear_fault_page(client, page);
+}
+
+void pmbus_clear_cml_faults(struct i2c_client *client)
+{
+ struct pmbus_data *data = i2c_get_clientdata(client);
+ int i;
+
+ for (i = 0; i < data->info->pages; i++)
+ pmbus_clear_cml_fault(client, i);
+}
+EXPORT_SYMBOL_NS_GPL(pmbus_clear_cml_faults, "PMBUS");
+
static int pmbus_check_status_cml(struct i2c_client *client)
{
struct pmbus_data *data = i2c_get_clientdata(client);
@@ -745,7 +765,7 @@ static bool pmbus_check_register(struct i2c_client *client,
if (rv < 0 && (data->flags & PMBUS_READ_STATUS_AFTER_FAILED_CHECK))
data->read_status(client, -1);
if (reg < PMBUS_VIRT_BASE)
- pmbus_clear_fault_page(client, -1);
+ pmbus_clear_cml_fault(client, -1);
return rv >= 0;
}
@@ -762,7 +782,7 @@ static bool pmbus_check_status_register(struct i2c_client *client, int page)
status = -EIO;
}
- pmbus_clear_fault_page(client, -1);
+ pmbus_clear_cml_fault(client, -1);
return status >= 0;
}
@@ -790,7 +810,7 @@ static bool __maybe_unused pmbus_check_block_register(struct i2c_client *client,
rv = pmbus_check_status_cml(client);
if (rv < 0 && (data->flags & PMBUS_READ_STATUS_AFTER_FAILED_CHECK))
data->read_status(client, -1);
- pmbus_clear_fault_page(client, -1);
+ pmbus_clear_cml_fault(client, -1);
return rv >= 0;
}
@@ -3053,9 +3073,9 @@ static int pmbus_init_common(struct i2c_client *client, struct pmbus_data *data,
}
if (data->info->pages)
- pmbus_clear_faults(client);
+ pmbus_clear_cml_faults(client);
else
- pmbus_clear_fault_page(client, -1);
+ pmbus_clear_cml_fault(client, -1);
if (info->identify) {
ret = (*info->identify)(client, info);
--
2.56.1.703.gf848ed807c-goog
reply other threads:[~2026-11-19 1:32 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261119013208.4089480-1-akorn@google.com \
--to=akorn@google.com \
--cc=linux-hwmon@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@roeck-us.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®