Re: [PATCH RFC v2 4/5] arm64: dts: qcom: nord-ride-embedded: Add sound support

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 10/21/26 9:36 AM, Shawn Guo wrote:
> From: Mohammad Rafi Shaik <mohammad.rafi.shaik@oss.qualcomm.com>
> 
> Enable audio on the nord-ride-embedded board. Add a soundcard node using
> the qcom,nord-sndcard compatible.
> 
> Add PCM1681/ADAU1979 codec nodes on I2C18, with the PCM1681 system
> clock supplied via MCLK0. The DAC control lines come off a TCA6408 I/O
> expander on the same bus.
> 
> Describe DAC_ENABLE as the enable of two regulator-fixed supplies
> (3.3V and 5V load switches) feeding the PCM1681, and the three MAX9892
> click-and-pop suppressors as one simple-audio-amplifier on
> CLICK_POP_MUTE_N, routed after VOUT1..6, so DAPM controls the mute.

[...]

> +	expander0: gpio@20 {
> +		compatible = "ti,tca6408";
> +		reg = <0x20>;
> +		#gpio-cells = <2>;
> +		gpio-controller;
> +		#interrupt-cells = <2>;
> +		interrupt-controller;
> +		interrupts-extended = <&pmau0102_l_gpios 6 IRQ_TYPE_LEVEL_LOW>;
> +		reset-gpios = <&pmau0102_l_gpios 5 GPIO_ACTIVE_LOW>;
> +		vcc-supply =<&vreg_per_3p3>;

nit, missing space after assignment

otherwise

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>

Konrad