Re: [RESEND v6 8/8] arm64: dts: qcom: sc7280: Add qcom,adsp-pil-mode property in clock nodes

[Mohammad Rafi Shaik <quic_mohs@quicinc.com>]

On 6/16/2023 5:06 PM, Konrad Dybcio wrote:
> On 16.06.2023 12:35, Mohammad Rafi Shaik wrote:
>> From: Srinivasa Rao Mandadapu <quic_srivasam@quicinc.com>
>>
>> Add "qcom,adsp-pil-mode" property in clock nodes for herobrine
>> crd revision 3 board specific device tree.
>> This is to register clocks conditionally by differentiating ADSP
>> based platforms and legacy path platforms.
>> Also disable lpass_core clock, as it is creating conflict
>> with ADSP clocks and it is not required for ADSP based platforms.
>>
>> Signed-off-by: Srinivasa Rao Mandadapu <quic_srivasam@quicinc.com>
>> Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
>> ---
>>   .../qcom/sc7280-herobrine-audioreach-wcd9385.dtsi    | 12 ++++++++++++
>>   1 file changed, 12 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/sc7280-herobrine-audioreach-wcd9385.dtsi b/arch/arm64/boot/dts/qcom/sc7280-herobrine-audioreach-wcd9385.dtsi
>> index c02ca393378f..876a29178d46 100644
>> --- a/arch/arm64/boot/dts/qcom/sc7280-herobrine-audioreach-wcd9385.dtsi
>> +++ b/arch/arm64/boot/dts/qcom/sc7280-herobrine-audioreach-wcd9385.dtsi
>> @@ -197,6 +197,14 @@ q6prmcc: clock-controller {
>>   	};
>>   };
>>   
>> +&lpass_aon {
>> +	qcom,adsp-pil-mode;
> That's a whole bunch of hacky bindings that makes no sense..
>
> What should have been done from the beginning is:
>
> - all clocks should be registered inside the clock driver, unconditionally
>    as far as .c code is concerned
>
> - the regmap properties within should reflect the actual max register
>    range within the hardware block
>
> - device-tree should contain protected-clocks, which omits registering
>    specified clks (I guess in the ADSP-less case you could probably even
>    register all of them and it wouldn't hurt)
>
For AR solution, it is required to add "qcom,adsp-pil-mode" flag to 
enable ahbm and ahbs clocks.
Please refer: 
https://elixir.bootlin.com/linux/v6.4-rc7/source/drivers/clk/qcom/lpassaudiocc-sc7280.c
>> +};
>> +
>> +&lpass_core {
>> +	status = "disabled";
> status = "reserved";
>
> Konrad
Okay, will change status flag.

Rafi
>> +};
>> +
>>   &lpass_rx_macro {
>>   	/delete-property/ power-domains;
>>   	/delete-property/ power-domain-names;
>> @@ -239,3 +247,7 @@ &lpass_va_macro {
>>   
>>   	status = "okay";
>>   };
>> +
>> +&lpasscc {
>> +	qcom,adsp-pil-mode;
>> +};