Re: [PATCH v4 12/12] interconnect: qcom: icc-rpm: Allow negative QoS offset

[Dmitry Baryshkov <dmitry.baryshkov@linaro.org>]

On 14/02/2023 16:37, Konrad Dybcio wrote:
> In some very very very very unfortunate cases, the correct offset of
> the QoS registers will be.. negative. One such case is MSM8998, where
> The DDR BWMON occupies what-would-be-the-BIMC-base which we usually
> take into account with the register calculation, making the actual
> BIMC node start at what-would-be-the-BIMC-base+0x300.
> 
> In order to keep the calculation code sane, the simplest - however
> ugly it may be - solution is to allow the offset to be negative.

I'm not sure how does this work, as e.g. qcom_icc_set_qnoc_qos() will 
try to access an address before the first register. Most probably this 
patch should go together with the rest of msm8998 patches.

A slightly better solution to making qos_offset negative might be to 
make bwmon a child node of the icc.

> 
> Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
> ---
>   drivers/interconnect/qcom/icc-rpm.h | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/interconnect/qcom/icc-rpm.h b/drivers/interconnect/qcom/icc-rpm.h
> index 77e263b93c27..5e4215f25c2e 100644
> --- a/drivers/interconnect/qcom/icc-rpm.h
> +++ b/drivers/interconnect/qcom/icc-rpm.h
> @@ -39,7 +39,7 @@ struct qcom_icc_provider {
>   	int num_intf_clks;
>   	enum qcom_icc_type type;
>   	struct regmap *regmap;
> -	unsigned int qos_offset;
> +	int qos_offset;
>   	u64 bus_clk_rate[2];
>   	bool keep_alive;
>   	struct clk_bulk_data bus_clks[2];
> @@ -105,7 +105,7 @@ struct qcom_icc_desc {
>   	bool keep_alive;
>   	enum qcom_icc_type type;
>   	const struct regmap_config *regmap_cfg;
> -	unsigned int qos_offset;
> +	int qos_offset;
>   };
>   
>   /* Valid for all bus types */

-- 
With best wishes
Dmitry