Re: [PATCH RFC 1/3] arm64: dts: qcom: nord: Add Ethernet support

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 11/4/26 9:42 AM, Shawn Guo wrote:
> On Wed, Nov 04, 2026 at 09:04:33AM +0100, Konrad Dybcio wrote:
>> On 11/4/26 8:59 AM, Shawn Guo wrote:
>>> On Mon, Nov 02, 2026 at 04:01:03PM +0100, Konrad Dybcio wrote:
>>>> On 11/1/26 9:04 AM, Shawn Guo wrote:
>>>>> From: Mohd Ayaan Anwar <mohd.anwar@oss.qualcomm.com>
>>>>>
>>>>> Describe both Nord 10-Gbps Ethernet controllers, including their XPCS and
>>>>> SerDes blocks, clocks, resets, power domains, interconnects, SMMU streams
>>>>> and DMA queues.
>>>>>
>>>>> Signed-off-by: Mohd Ayaan Anwar <mohd.anwar@oss.qualcomm.com>
>>>>> Signed-off-by: Shawn Guo <shengchao.guo@oss.qualcomm.com>
>>>>> ---
>>>>
>>>> [...]
>>>>
>>>>> +	phys = <&serdes0>;
>>>>> +	phy-names = "serdes";
>>>>
>>>> I believe this holds for both GearVM and embedded, so you can move
>>>> it to the common DTSI
>>>
>>> No, this doesn't apply to GearVM. The SerDes is owned entirely by the SCMI
>>> server firmware for GearVM variant. LDOs, clkref, reset, and the per-speed
>>> PLL/RX/TX programming driven by an SCMI perf domain whose level is
>>> the link speed.
>>
>> Right, but I meant the assignment to the EMACs specifically
> 
> The EMAC0/SerDes0 and EMAC1/SerDes1 pairing is indeed the same on both
> variants. But the serdes nodes only exist in nord-embedded.dtsi, since
> GearVM doesn't expose the PHY to Linux. Or am I missing your point
> completely?

No, I was just completely sure that the nodes exist in the gvm one too
because it seems like they do on lemans:

https://lore.kernel.org/linux-arm-msm/20261103-sa8255p-eth-phy-v18-1-b00cc2fa0404@oss.qualcomm.com/

Konrad