Re: [PATCH v1 1/2] Add the iio driver for bosch pressure sensor bmp390. The bmp390 is a pressure sensor module. It will support SPI and I2C protocol based on configuration.

[David Lechner <dlechner@baylibre.com>]

On 6/19/25 11:54 PM, liquancin.mereenamathai@in.bosch.com wrote:
> From: Liquancin Mereena Mathai <liquancin.mereenamathai@in.bosch.com>
> 
> Implemented features:
> * raw data access for pressure and temp through sysfs
> * iio buffer tool support for continuous sampling

A driver only doing these two things should be 100s of lines, not
thousands. Clearly, there is a lot more going on than this.

So in addition to Krzysztof's advice, please split out the driver into
separate patches for different features. Ideally a whole series is 1000
or maybe 1500 lines max and individual patches 500 lines max. This will
make it much easier to review and it will give you a chance to explain
things in more detail in each commit message.

> 
> Signed-off-by: Liquancin Mereena Mathai <liquancin.mereenamathai@in.bosch.com>
> ---
>  MAINTAINERS                                   |    7 +
>  drivers/iio/pressure/Kconfig                  |   26 +
>  drivers/iio/pressure/Makefile                 |    1 +
>  drivers/iio/pressure/bmp390/Kconfig           |   29 +
>  drivers/iio/pressure/bmp390/Makefile          |   32 +
>  drivers/iio/pressure/bmp390/bmp3.c            | 2781 +++++++++++++++++
>  drivers/iio/pressure/bmp390/bmp3.h            |  537 ++++
>  drivers/iio/pressure/bmp390/bmp390_driver.c   | 1604 ++++++++++
>  drivers/iio/pressure/bmp390/bmp390_driver.h   |  232 ++
>  drivers/iio/pressure/bmp390/bmp390_i2c.c      |  328 ++
>  .../iio/pressure/bmp390/bmp390_iio_buffer.c   |  220 ++
>  drivers/iio/pressure/bmp390/bmp390_spi.c      |  286 ++
>  drivers/iio/pressure/bmp390/bmp3_defs.h       |  871 ++++++
>  drivers/iio/pressure/bmp390/bmp3_selftest.c   |  184 ++
>  drivers/iio/pressure/bmp390/bmp3_selftest.h   |   93 +
>  15 files changed, 7231 insertions(+)