[PATCH] gpio/gpio-stmpe: Fix the value returned by _get_value routine

[Viresh Kumar <viresh.kumar@st.com>]

From: Bhupesh Sharma <bhupesh.sharma@st.com>

The present _get_value routine returns the contents of the GPIO
Monitor Pin Status Register(GPMR) starting from the bit whose value
is requested to BIT 0.

For e.g. if we request the value of GPIO 6 in the earlier
implementation the value returned is:

	BIT6 to BIT0

whereas it should just return BIT6.

This patch addresses the same.

Signed-off-by: Bhupesh Sharma <bhupesh.sharma@st.com>
Reviewed-by: Viresh Kumar <viresh.kumar@st.com>
---
 drivers/gpio/gpio-stmpe.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index 094c5c4..dce3472 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -54,7 +54,7 @@ static int stmpe_gpio_get(struct gpio_chip *chip, unsigned offset)
 	if (ret < 0)
 		return ret;
 
-	return ret & mask;
+	return !!(ret & mask);
 }
 
 static void stmpe_gpio_set(struct gpio_chip *chip, unsigned offset, int val)
-- 
1.7.8.110.g4cb5d