Re: [PATCH 6.1 000/221] 6.1.77-rc2 review

["Mateusz Jończyk" <mat.jonczyk@o2.pl>]

W dniu 3.02.2024 o 18:52, Greg Kroah-Hartman pisze:
> This is the start of the stable review cycle for the 6.1.77 release.
> There are 221 patches in this series, all will be posted as a response
> to this one.  If anyone has any issues with these being applied, please
> let me know.
>
> Responses should be made by Mon, 05 Feb 2024 17:47:20 +0000.
> Anything received after that time might be too late.
>
> The whole patch series can be found in one patch at:
> 	https://www.kernel.org/pub/linux/kernel/v6.x/stable-review/patch-6.1.77-rc2.gz
> or in the git tree and branch at:
> 	git://git.kernel.org/pub/scm/linux/kernel/git/stable/linux-stable-rc.git linux-6.1.y
> and the diffstat can be found below.
>
> thanks,
>
> greg k-h

Hello,

Tested-on a HP 17-by0001nw laptop with an Intel Kaby Lake CPU and Ubuntu 20.04.

Used technologies: ext4, vfat, mdraid on top of a NVMe and SATA drive (in a
write-mostly mode).

Suspend to disk and suspend to RAM work.

Nitpicks:

- the laptop once failed to shut down completely, it hung with a black screen
(the kernel messages from the shutdown disappeared). This did not happen again
with 2-3 tries. IIRC this has happened on this laptop in the past.

- I have been running long SMART tests on 2 external USB hard drives.
One of them, a TOSHIBA USB 3.0 hard drive briefly disconnected with the
following dmesg messages:

usb 2-2: USB disconnect, device number 4
xhci_hcd 0000:00:14.0: WARN Set TR Deq Ptr cmd failed due to incorrect slot or ep state.
sd 2:0:0:0: [sdc] tag#0 FAILED Result: hostbyte=DID_ERROR driverbyte=DRIVER_OK cmd_age=0s
sd 2:0:0:0: [sdc] tag#0 CDB: ATA command pass through(16) 85 06 20 00 00 00 00 00 00 00 00 00 00 00 e5 00
device offline error, dev sdc, sector 263659521 op 0x1:(WRITE) flags 0x0 phys_seg 1 prio class 2
Buffer I/O error on dev sdc2, logical block 1, lost async page write
sd 2:0:0:0: [sdc] Synchronizing SCSI cache
sd 2:0:0:0: [sdc] Synchronize Cache(10) failed: Result: hostbyte=DID_NO_CONNECT driverbyte=DRIVER_OK
usb 2-2: new SuperSpeed USB device number 5 using xhci_hcd

The hard drive was later reset out of the blue:

usb 2-1: reset SuperSpeed USB device number 7 using xhci_hcd

This may have been caused by faulty cabling / USB sockets.

Tested-by: Mateusz Jończyk <mat.jonczyk@o2.pl>

Greetings,

Mateusz Jończyk