[PATCH 2/2] ACPI / PM: Fix device power state value after transitions to D3cold

["Rafael J. Wysocki" <rjw@sisk.pl>]

From: Rafael J. Wysocki <rafael.j.wysocki@intel.com>

When a transition to the D3cold power state is requested,
acpi_device_set_power() first carries out a transition to D3hot and
then turns off the device's power resources.  However, it fails to
update the device's power.state field appropriately and D3hot is
stored in it as a result.

Fix this, but make sure that the device's power.state value will be
D3hot if its power resources cannot be turned off in the final step.

Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
---
 drivers/acpi/device_pm.c |    7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

Index: linux-pm/drivers/acpi/device_pm.c
===================================================================
--- linux-pm.orig/drivers/acpi/device_pm.c
+++ linux-pm/drivers/acpi/device_pm.c
@@ -264,8 +264,11 @@ int acpi_device_set_power(struct acpi_de
 	if (result)
 		goto end;
 
-	if (cut_power)
-		result = acpi_power_transition(device, ACPI_STATE_D3_COLD);
+	if (cut_power) {
+		device->power.state = state;
+		state = ACPI_STATE_D3_COLD;
+		result = acpi_power_transition(device, state);
+	}
 
  end:
 	if (result) {