Re: [PATCH] crypto: hisilicon/sec - Fix a module parameter error

[liulongfang <liulongfang@huawei.com>]

On 2021/3/27 17:29, Longfang Liu Wrote:
> ctx_q_num is a module parameter set by the user to specify the
> number of qp queues required to create a ctx.
> 
> When the number of qp queues allocated by PF or VF is less than
> the ctx_q_num, an error will be reported when ctx is initialized
> in kernel mode, which leads to the problem that the registered
> algorithms cannot be used.
> 
> Therefore, when PF or VF is initialized, if the number of qp queues
> is not enough to create a ctx, the kernel mode cannot be used,
> and there is no need to register the kernel mode algorithms.
> 
> Signed-off-by: Longfang Liu <liulongfang@huawei.com>
> ---
>  drivers/crypto/hisilicon/sec2/sec_main.c | 13 +++++++++----
>  1 file changed, 9 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/crypto/hisilicon/sec2/sec_main.c b/drivers/crypto/hisilicon/sec2/sec_main.c
> index b1818f7..c7b71b6 100644
> --- a/drivers/crypto/hisilicon/sec2/sec_main.c
> +++ b/drivers/crypto/hisilicon/sec2/sec_main.c
> @@ -867,10 +867,15 @@ static int sec_probe(struct pci_dev *pdev, const struct pci_device_id *id)
>  	if (ret)
>  		pci_warn(pdev, "Failed to init debugfs!\n");
>  
> -	ret = hisi_qm_alg_register(qm, &sec_devices);
> -	if (ret < 0) {
> -		pr_err("Failed to register driver to crypto.\n");
> -		goto err_qm_stop;
> +	if (qm->qp_num >= ctx_q_num) {
> +		ret = hisi_qm_alg_register(qm, &sec_devices);
> +		if (ret < 0) {
> +			pr_err("Failed to register driver to crypto.\n");
> +			goto err_qm_stop;
> +		}
> +	} else {
> +		pci_warn(qm->pdev,
> +			"Failed to use kernel mode, qp not enough!\n");
>  	}
>  
>  	if (qm->uacce) {
> 
Sorry, please don't reply to this patch, I will resend it again.
Thanks,
Longfang