Re: [PATCH v6 2/2] arm64: dts: qcom: ipq5424: Enable PCIe PHYs and controllers

[Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>]

On 08/04/2025 15:49, Manikanta Mylavarapu wrote:
> 
> 
> On 4/3/2025 3:02 PM, Dmitry Baryshkov wrote:
>> On Thu, 3 Apr 2025 at 08:08, Manikanta Mylavarapu
>> <quic_mmanikan@quicinc.com> wrote:
>>>
>>>
>>>
>>> On 4/2/2025 7:50 PM, Dmitry Baryshkov wrote:
>>>> On Wed, Apr 02, 2025 at 03:57:23PM +0530, Manikanta Mylavarapu wrote:
>>>>> Enable the PCIe controller and PHY nodes corresponding to RDP466.
>>>>>
>>>>> Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@quicinc.com>
>>>>> ---
>>>>> Changes in V6:
>>>>>       - No change.
>>>>>
>>>>>   arch/arm64/boot/dts/qcom/ipq5424-rdp466.dts | 41 ++++++++++++++++++++-
>>>>>   1 file changed, 40 insertions(+), 1 deletion(-)
>>>>>
>>>>> diff --git a/arch/arm64/boot/dts/qcom/ipq5424-rdp466.dts b/arch/arm64/boot/dts/qcom/ipq5424-rdp466.dts
>>>>> index 0fd0ebe0251d..1f89530cb035 100644
>>>>> --- a/arch/arm64/boot/dts/qcom/ipq5424-rdp466.dts
>>>>> +++ b/arch/arm64/boot/dts/qcom/ipq5424-rdp466.dts
>>>>> @@ -82,6 +82,32 @@ &dwc_1 {
>>>>>       dr_mode = "host";
>>>>>   };
>>>>>
>>>>> +&pcie2 {
>>>>> +    pinctrl-0 = <&pcie2_default_state>;
>>>>> +    pinctrl-names = "default";
>>>>> +
>>>>> +    perst-gpios = <&tlmm 31 GPIO_ACTIVE_LOW>;
>>>>
>>>>
>>>> No wake-gpios? Please document it in the commit message.
>>>>
>>>
>>> Hi Dmitry,
>>>
>>> Thank you for reviewing the patch.
>>>
>>> The wake GPIO is dropped because the PCIe on the IPQ5424 doesn't support low power mode.
>>> I will document this information in the commit message and post the next version.
>>
>> If the GPIO is routed on the PCB I think it should still be described in the DT.
>>
>>
> 
> Hi Dmitry,
> 
> 	I have confirmed with the hardware team that the wake GPIO is not routed on the PCB.

Sad. Please mention it in the commit message.

> 
> Thanks & Regards,
> Manikanta.
> 


-- 
With best wishes
Dmitry