From: Leslie Donaldson <donaldlf@hermes.cs.rose-hulman.edu>
To: "Justin T. Gibbs" <gibbs@scsiguy.com>
Cc: Leslie Donaldson <donaldlf@hermes.cs.rose-hulman.edu>,
Alan Cox <alan@lxorguk.ukuu.org.uk>,
linux-kernel@vger.kernel.org
Subject: Re: Patch for aic7xxx 2.4.0 test12 hang
Date: Fri, 19 Jan 2001 12:05:45 -0600 [thread overview]
Message-ID: <3A6881F9.17F7B9F6@mailhost.cs.rose-hulman.edu> (raw)
In-Reply-To: <200101191756.f0JHuns30179@aslan.scsiguy.com>
"Justin T. Gibbs" wrote:
>
> >This is a temporary patch to keep the scsi driver from eating
> >your data.... I am working on a real fix....
> >
> >Leslie Donaldson
>
> What is the firmware revision of your Seagate drives?
Not using seagate drives this is with quantum
see bottom....
> There
> were several models shipped in the recent past with firware that
> would cause the drive to drop off the bus under high load.
Ummm o the controller card...
00:06.0 SCSI storage controller: Adaptec 7899A (rev 01)
Subsystem: Adaptec: Unknown device f620
Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 16
BIST result: 00
I/O ports at 8000 [size=256]
Memory at 000000000c864000 (64-bit, non-prefetchable) [size=4K]
Expansion ROM at 000000000c800000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 2
00:06.1 SCSI storage controller: Adaptec 7899A (rev 01)
Subsystem: Adaptec: Unknown device f620
Flags: bus master, 66Mhz, medium devsel, latency 32, IRQ 23
BIST result: 00
I/O ports at 8400 [size=256]
Memory at 000000000c865000 (64-bit, non-prefetchable) [size=4K]
Expansion ROM at 000000000c820000 [disabled] [size=128K]
Capabilities: [dc] Power Management version 2
> There is also a known issue with U160 modes and the currently
> embedded aic7xxx driver.
That's true the problem is the TCQ command seems to be sequencing wrong.
>You might want to try the Adaptec
> supported driver from here:
>
> http://people.FreeBSD.org/~gibbs/linux/
>
> 6.09 BETA should be released later today.
I'll try it later tonight,
> --
> Justin
Jan 19 11:23:40 shadowdragon kernel: SCSI subsystem driver Revision:
1.00
Jan 19 11:23:40 shadowdragon kernel: (scsi0) <Adaptec AIC-7899 Ultra
160/m SCSI host adapter> found at PCI 0/6/0
Jan 19 11:23:40 shadowdragon kernel: (scsi0) Wide Channel A, SCSI ID=7,
32/255 SCBs
Jan 19 11:23:40 shadowdragon kernel: (scsi0) Downloading sequencer
code... 392 instructions downloaded
Jan 19 11:23:41 shadowdragon pcmcia: Starting PCMCIA services:
Jan 19 11:23:40 shadowdragon kernel: (scsi1) <Adaptec AIC-7899 Ultra
160/m SCSI host adapter> found at PCI 0/6/1
Jan 19 11:23:40 shadowdragon kernel: (scsi1) Wide Channel B, SCSI ID=7,
32/255 SCBs
Jan 19 11:23:40 shadowdragon kernel: (scsi1) Downloading sequencer
code... 392 instructions downloaded
Jan 19 11:23:40 shadowdragon kernel: scsi0 : Adaptec AHA274x/284x/294x
(EISA/VLB/PCI-Fast SCSI) 5.2.1/5.2.0
Jan 19 11:23:40 shadowdragon kernel: <Adaptec AIC-7899 Ultra
160/m SCSI host adapter>
Jan 19 11:23:40 shadowdragon kernel: scsi1 : Adaptec AHA274x/284x/294x
(EISA/VLB/PCI-Fast SCSI) 5.2.1/5.2.0
Jan 19 11:23:40 shadowdragon kernel: <Adaptec AIC-7899 Ultra
160/m SCSI host adapter>
Jan 19 11:23:40 shadowdragon kernel: (scsi0:0:3:0) Synchronous at 5.0
Mbyte/sec, offset 8.
Jan 19 11:23:40 shadowdragon kernel: Vendor: FUJITSU Model:
M2512A Rev: 1408
Jan 19 11:23:40 shadowdragon kernel: Type: Optical
Device ANSI SCSI revision: 02
Jan 19 11:23:40 shadowdragon kernel: (scsi0:0:4:0) Synchronous at 10.0
Mbyte/sec, offset 8.
Jan 19 11:23:40 shadowdragon kernel: Vendor: TOSHIBA Model: CD-ROM
XM-5701TA Rev: 0167
Jan 19 11:23:40 shadowdragon kernel: Type:
CD-ROM ANSI SCSI revision: 02
Jan 19 11:23:40 shadowdragon kernel: (scsi1:0:0:0) Synchronous at 80.0
Mbyte/sec, offset 31.
Jan 19 11:23:40 shadowdragon kernel: Vendor: QUANTUM Model: ATLAS
10K 18WLS Rev: UC81
Jan 19 11:23:40 shadowdragon kernel: Type:
Direct-Access ANSI SCSI revision: 03
Jan 19 11:23:40 shadowdragon kernel: (scsi1:0:0:0) DISABLED TAGGED
QUEUING, queue depth 0.
Jan 19 11:23:40 shadowdragon kernel: Detected scsi removable disk sda at
scsi0, channel 0, id 3, lun 0
Jan 19 11:23:40 shadowdragon kernel: Detected scsi disk sdb at scsi1,
channel 0, id 0, lun 0
Jan 19 11:23:40 shadowdragon kernel: sda : READ CAPACITY failed.
Jan 19 11:23:40 shadowdragon kernel: sda : status = 1, message = 00,
host = 0, driver = 28
Jan 19 11:23:40 shadowdragon kernel: sda : extended sense code = 2
Jan 19 11:23:40 shadowdragon kernel: sda : block size assumed to be 512
bytes, disk size 1GB.
Jan 19 11:23:40 shadowdragon kernel: Partition check:
Jan 19 11:23:40 shadowdragon kernel: sda: I/O error: dev 08:00, sector
0
Jan 19 11:23:41 shadowdragon pcmcia: modules
Jan 19 11:23:40 shadowdragon kernel: unable to read partition table
Jan 19 11:23:40 shadowdragon kernel: SCSI device sdb: 35877972 512-byte
hdwr sectors (18370 MB)
Jan 19 11:23:40 shadowdragon kernel: sdb: sdb1 sdb2 sdb3 sdb4
Jan 19 11:23:40 shadowdragon kernel: Detected scsi CD-ROM sr0 at scsi0,
channel 0, id 4, lun 0
Jan 19 11:23:40 shadowdragon kernel: Uniform CD-ROM driver Revision:
3.11
--
/----------------------------\ Current Contractor: None
| Leslie F. Donaldson | Current Customer : None
| Computer Contractor | Skills:
Unix/OS9/VMS/Linux/SUN-OS/C/C++/assembly
| Have Computer will travel. | WWW :
http://www.cs.rose-hulman.edu/~donaldlf
\----------------------------/ Email: mail://donaldlf@cs.rose-hulman.edu
Goth Code V1.1: GoCS$$ TYg(T6,T9) B11Bk!^1 C6b-- P0(1,7) M+ a24 n---
b++:+
H6'11" g m---- w+ r+++ D--~!% h+ s10 k+++ R-- Ssw
LusCA++
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
Please read the FAQ at http://www.tux.org/lkml/
next prev parent reply other threads:[~2001-01-19 18:13 UTC|newest]
Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top
2001-01-19 17:40 Leslie Donaldson
2001-01-19 17:56 ` Justin T. Gibbs
2001-01-19 18:05 ` Leslie Donaldson [this message]
2001-01-19 21:00 ` Jeff Hartmann
2001-01-20 2:48 ` Leslie Donaldson
2001-01-22 5:30 ` Leslie Donaldson
2001-01-22 16:15 ` Gregory McLean
2001-01-25 3:02 ` Justin T. Gibbs
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=3A6881F9.17F7B9F6@mailhost.cs.rose-hulman.edu \
--to=donaldlf@hermes.cs.rose-hulman.edu \
--cc=alan@lxorguk.ukuu.org.uk \
--cc=gibbs@scsiguy.com \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®