Hi! Alan Cox wrote: > > > switch. To see if it's a hardware problem I already switched > > back to 2.2.18 once, and the problem went away. > > Under 2.2.20 I have to boot with "noapic" to have it running > > smoothly. > > Does 2.2.19 work ? I quickly installed 2.2.19 on this machine. It is running this kernel right now, and everything seems to run fine _without_ the "noapic" option, i.e. no need to give any special command line option to the kernel in order to get it running smoothly! I also have MPS 1.4 support _enabled_ in the BIOS (if that's of any importance, anyway) It's running for about 15 minutes now, under some load (several "find" jobs locally and over NFS), and it seems to be stable. With 2.2.20 I almost immediately get those "stuck on TLB IPI wait" messages, whereas with 2.2.19 I haven't seen any of them yet. (Note that this machine has 2GB of RAM, but the 2.2.19 kernel I have running right now was compiled with CONFIG_1GB, only) root@schiller:~ {515} $ uptime 5:17pm up 15 min, 3 users, load average: 2.08, 1.71, 0.98 root@schiller:~ {516} $ cat /proc/interrupts CPU0 CPU1 0: 92841 0 XT-PIC timer 1: 235 295 IO-APIC-edge keyboard 2: 0 0 XT-PIC cascade 4: 6 14 IO-APIC-edge serial 8: 1 3 IO-APIC-edge rtc 13: 1 0 XT-PIC fpu 18: 432265 431482 IO-APIC-level eth0 22: 243311 244776 IO-APIC-level aic7xxx NMI: 0 ERR: 0 Please find the output of "dmesg" and "lspci -v" attached to this mail. If you have anything more for me to test (maybe a small kernel patch for 2.2.20 ;-) I'll be glad if I can help. - andreas -- Andreas Haumer | mailto:andreas@xss.co.at *x Software + Systeme | http://www.xss.co.at/ Karmarschgasse 51/2/20 | Tel: +43-1-6060114-0 A-1100 Vienna, Austria | Fax: +43-1-6060114-71