Linux version 2.5.7 (grev@silver) (gcc version 2.95.2 19991024 (release)) #1 SMP Fri Mar 29 16:20:45 MSK 2002 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 00000000000a0000 (usable) BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000000fff0000 (usable) BIOS-e820: 000000000fff0000 - 000000000fff3000 (ACPI NVS) BIOS-e820: 000000000fff3000 - 0000000010000000 (ACPI data) BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved) 255MB LOWMEM available. On node 0 totalpages: 65520 zone(0): 4096 pages. zone(1): 61424 pages. zone(2): 0 pages. Kernel command line: auto BOOT_IMAGE=2.5.7 ro root=306 vga=0x0301 Local APIC disabled by BIOS -- reenabling. Found and enabled local APIC! Initializing CPU#0 Detected 698.666 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1392.64 BogoMIPS Memory: 256464k/262080k available (1241k kernel code, 5232k reserved, 430k data, 208k init, 0k highmem) Dentry-cache hash table entries: 32768 (order: 6, 262144 bytes) Inode-cache hash table entries: 16384 (order: 5, 131072 bytes) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes) Page-cache hash table entries: 65536 (order: 6, 262144 bytes) CPU: Before vendor init, caps: 0183fbff c1c3fbff 00000000, vendor = 2 CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 512K (64 bytes/line) CPU: After vendor init, caps: 0183fbff c1c3fbff 00000000 00000000 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0183fbff c1c3fbff 00000000 00000000 CPU: Common caps: 0183fbff c1c3fbff 00000000 00000000 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX CPU: Before vendor init, caps: 0183fbff c1c3fbff 00000000, vendor = 2 CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 512K (64 bytes/line) CPU: After vendor init, caps: 0183fbff c1c3fbff 00000000 00000000 Intel machine check reporting enabled on CPU#0. CPU: After generic, caps: 0183fbff c1c3fbff 00000000 00000000 CPU: Common caps: 0183fbff c1c3fbff 00000000 00000000 WARNING: This combination of AMD processors is not suitable for SMP. CPU0: AMD Athlon(tm) Processor stepping 01 per-CPU timeslice cutoff: 1463.62 usecs. task migration cache decay timeout: 10 msecs. SMP motherboard not detected. enabled ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 698.6489 MHz. ..... host bus clock speed is 199.6139 MHz. cpu: 0, clocks: 1996139, slice: 998069 CPU0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket PCI: PCI BIOS revision 2.10 entry at 0xfb430, last bus=1 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) Starting kswapd BIO: pool of 256 setup, 14Kb (56 bytes/bio) biovec: init pool 0, 1 entries, 12 bytes biovec: init pool 1, 4 entries, 48 bytes biovec: init pool 2, 16 entries, 192 bytes biovec: init pool 3, 64 entries, 768 bytes biovec: init pool 4, 128 entries, 1536 bytes biovec: init pool 5, 256 entries, 3072 bytes VFS: Diskquotas version dquot_6.4.0 initialized Detected PS/2 Mouse Port. pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A block: 256 slots per queue, batch=32 Intel(R) PRO/100 Fast Ethernet Adapter - Loadable driver, ver 2.0.24-pre1 Copyright (c) 2002 Intel Corporation eth0: Intel(R) PRO/100+ Management Adapter Mem:0xe5101000 IRQ:11 Speed:100 Mbps Dx:Full Hardware receive checksums enabled cpu cycle saver enabled [drm] Initialized tdfx 1.0.0 20010216 on minor 0 Uniform Multi-Platform E-IDE driver ver.:7.0.0 ide: system bus speed 33MHz Advanced Micro Devices [AMD] AMD-756 [Viper] IDE: IDE controller on PCI slot 00:07.1 Advanced Micro Devices [AMD] AMD-756 [Viper] IDE: chipset revision 3 Advanced Micro Devices [AMD] AMD-756 [Viper] IDE: not 100% native mode: will probe irqs later AMD_IDE: Advanced Micro Devices [AMD] AMD-756 [Viper] IDE (rev 03) UDMA66 controller on pci00:07.1 ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:pio hda: IBM-DJNA-371800, ATA DISK drive hdc: SONY CDU4811, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 blk: queue c033dd0c, I/O limit 4095Mb (mask 0xffffffff) hda: 35239680 sectors (18043 MB) w/1966KiB Cache, CHS=34960/16/63, (U)DMA Partition check: hda: [PTBL] [2193/255/63] hda1 hda2 hda3 hda4 < hda5 hda6 hda7 hda8 hda9 > Advanced Linux Sound Architecture Driver Version 0.9.0beta12 (Mon Mar 18 15:44:40 2002 UTC). kmod: failed to exec /sbin/modprobe -s -k snd-card-0, errno = 2 ALSA device list: No soundcards found. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 1024 buckets, 16Kbytes TCP: Hash tables configured (established 8192 bind 10922) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 208k freed hda: dma_intr: status=0x51 { DriveReady SeekComplete Error } hda: dma_intr: error=0x84 { DriveStatusError BadCRC } hda: dma_intr: status=0x51 { DriveReady SeekComplete Error } hda: dma_intr: error=0x84 { DriveStatusError BadCRC } hda: dma_intr: status=0x51 { DriveReady SeekComplete Error } hda: dma_intr: error=0x84 { DriveStatusError BadCRC } hda: dma_intr: status=0x51 { DriveReady SeekComplete Error } hda: dma_intr: error=0x84 { DriveStatusError BadCRC } ide0: reset: success Adding Swap: 136544k swap-space (priority -1)