Uniform multi-platform eide driver revision: 7.00beta-2.4
ide: assuming 33mhz system buys speed for pio modes; override with idebus=xx
hda: compaq cdr-8435, atapi cd/dvd-rom drive
hdc: fujitsu mpd3108AT, ata disk drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hdc: 19541088 sectors (10005 MB) w/ 512KiB cache, CHS=19386/16/63
hda: atapi 32x cd-rom driver, 128kB cache
uniform cd-rom driver revision: 3.12
partition check:
 hdc: hdc1 hdc2 hdc3
ali15x3: ide controller at PCI slot 00:0d.0
ali15x3: chipset revision 193
ali15x3: not 100% native mode, will probe irqs later
  ide0: bm-dma at 0x8420-0x8427, bios settings: hda:pio, hdb:pio
  ide1: bm-dma at 0x8428-0x842f, bios settings: hdc:pio, hdd:pio
hdc:hdc: status timeout: status=0xff {busy}

hdc: drive not ready for command

ide1:reset timed-out, status=0xff
hdc: status timeout: status=0xff {busy}
hdc: drive not ready for command
[...stuff scrolls off screen too fast to read...]
end_request: I/O error, dev 16:00 (hdc), sector 2
end_request: I/O error, dev 16:00 (hdc), sector 4
end_request: I/O error, dev 16:00 (hdc), sector 6
end_request: I/O error, dev 16:00 (hdc), sector 8
end_request: I/O error, dev 16:00 (hdc), sector 10
end_request: I/O error, dev 16:00 (hdc), sector 12
end_request: I/O error, dev 16:00 (hdc), sector 14
end_request: I/O error, dev 16:00 (hdc), sector 0
end_request: I/O error, dev 16:00 (hdc), sector 2
end_request: I/O error, dev 16:00 (hdc), sector 4
end_request: I/O error, dev 16:00 (hdc), sector 6
end_request: I/O error, dev 16:00 (hdc), sector 8
end_request: I/O error, dev 16:00 (hdc), sector 10
end_request: I/O error, dev 16:00 (hdc), sector 12
end_request: I/O error, dev 16:00 (hdc), sector 14
 unable to read partition table
[...continues with unrelated stuff, then panics due to no root fs...]