Re: [RFC] Bluetooth: Retry configure request if result is L2CAP_CONF_UNKNOWN

[Marcel Holtmann <marcel@holtmann.org>]

Hi Andrey,

> Due to:
> 
> - current implementation of l2cap_config_rsp() dropping BT
>   connection if sender of configuration response replied with unknown
>   option failure (Result=0x0003/L2CAP_CONF_UNKNOWN)
> 
> - current implementation of l2cap_build_conf_req() adding
>   L2CAP_CONF_RFC(0x04) option to initial configure request sent by
>   the Linux host.
> 
> devices that do no recongninze L2CAP_CONF_RFC, such as Xbox One S
> controllers, will get stuck in endless connect -> configure ->
> disconnect loop, never connect and be generaly unusable.
> 
> To avoid this problem add code to do the following:
> 
> 1. Store a mask of supported conf option types per connection
> 
> 2. Parse the body of response L2CAP_CONF_UNKNOWN and adjust
>    connection's supported conf option types mask
> 
> 3. Retry configuration step the same way it's done for
>    L2CAP_CONF_UNACCEPT
> 
> Signed-off-by: Andrey Smirnov <andrew.smirnov@gmail.com>
> Cc: Pierre-Loup A. Griffais <pgriffais@valvesoftware.com>
> Cc: Florian Dollinger <dollinger.florian@gmx.de>
> Cc: Marcel Holtmann <marcel@holtmann.org>
> Cc: Johan Hedberg <johan.hedberg@gmail.com>
> Cc: linux-bluetooth@vger.kernel.org
> Cc: linux-kernel@vger.kernel.org
> ---
> 
> Everyone:
> 
> I marked this as an RFC, since I don't have a lot of experience with
> Bluetooth subsystem and don't have hight degree of confidence about
> choices made in this patch. I do, however, thins is is good enough to
> start a discussion about the problem.

can you take a btmon -w trace.log protocol trace so that I can see where it fails. This seems a really odd behavior of the Xbox controller. We have to be careful in not breaking Bluetooth qualification to just workaround some buggy remote device.

Regards

Marcel