Linux version 2.4.23-pre3 (root@localhost.localdomain.net) (gcc version egcs-2.91.66 19990314 (egcs-1.1.2 release)) #4 Sun Sep 7 19:42:25 CEST 2003 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001dff0000 (usable) BIOS-e820: 000000001dff0000 - 000000001dffffc0 (ACPI data) BIOS-e820: 000000001dffffc0 - 000000001e000000 (ACPI NVS) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) user-defined physical RAM map: user: 0000000000000000 - 000000000009fc00 (usable) user: 000000000009fc00 - 00000000000a0000 (reserved) user: 00000000000e0000 - 0000000000100000 (reserved) user: 0000000000100000 - 000000001dff0000 (usable) 479MB LOWMEM available. On node 0 totalpages: 122864 zone(0): 4096 pages. zone(1): 118768 pages. zone(2): 0 pages. ACPI: RSDP (v000 OID_00 ) @ 0x000e5010 ACPI: RSDT (v001 INSYDE RSDT_000 0x00000001 _CSI 0x00010100) @ 0x1dfffbc0 ACPI: FADT (v001 INSYDE FACP_000 0x00000100 _CSI 0x00010100) @ 0x1dfffac0 ACPI: BOOT (v001 INSYDE SYS_BOOT 0x00000100 _CSI 0x00010100) @ 0x1dfffb50 ACPI: DBGP (v001 INSYDE DBGP_000 0x00000100 _CSI 0x00010100) @ 0x1dfffb80 ACPI: DSDT (v001 INSYDE VT8372 0x00001000 INTL 0x02002025) @ 0x00000000 ACPI: MADT not present Kernel command line: root=/dev/hda6 vga=0x318 gui=yes hdc=ide-scsi mem=491456K ide_setup: hdc=ide-scsi Local APIC disabled by BIOS -- reenabling. Found and enabled local APIC! Initializing CPU#0 Detected 1791.258 MHz processor. Console: colour dummy device 80x25 Calibrating delay loop... 3565.15 BogoMIPS Memory: 483884k/491456k available (1082k kernel code, 7184k reserved, 268k data, 276k init, 0k highmem) Dentry cache hash table entries: 65536 (order: 7, 524288 bytes) Inode cache hash table entries: 32768 (order: 6, 262144 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line) CPU: L2 Cache: 512K (64 bytes/line) Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: AMD mobile AMD Athlon(tm) XP-M 2400+ stepping 00 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX enabled ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 1791.2080 MHz. ..... host bus clock speed is 265.3641 MHz. cpu: 0, clocks: 2653641, slice: 1326820 CPU0 mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au) mtrr: detected mtrr type: Intel ACPI: Subsystem revision 20030813 PCI: PCI BIOS revision 2.10 entry at 0xe8b24, last bus=1 PCI: Using configuration type 1 ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: System [ACPI] (supports S0 S3 S4 S5) ACPI: PCI Root Bridge [PCI0] (00:00) PCI: Probing PCI hardware (bus 00) ACPI: Embedded Controller [EC0] (gpe 5) ACPI: PCI Interrupt Link [LNKA] (IRQs 5 7 *10 11) ACPI: PCI Interrupt Link [LNKB] (IRQs 7, enabled at IRQ 11) ACPI: PCI Interrupt Link [LNKC] (IRQs *5 7 10 11) ACPI: PCI Interrupt Link [LNKD] (IRQs 5 7 10 *11) PCI: Probing PCI hardware ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11 ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 5 ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 10 ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 10 PCI: No IRQ known for interrupt pin A of device 00:11.1 PCI: Using ACPI for IRQ routing PCI: if you experience problems, try using option 'pci=noacpi' or even 'acpi=off' Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd VFS: Disk quotas vdquot_6.5.1 ACPI: AC Adapter [AC] (on-line) ACPI: Battery Slot [BAT0] (battery present) ACPI: Power Button (FF) [PWRF] ACPI: Sleep Button (CM) [SBTN] ACPI: Lid Switch [LID] ACPI: Processor [CPU0] (supports C1 C2) vesafb: framebuffer at 0x90000000, mapped to 0xde80c000, size 6144k vesafb: mode is 1024x768x32, linelength=4096, pages=9 vesafb: protected mode interface info at c000:9979 vesafb: scrolling: redraw vesafb: directcolor: size=8:8:8:8, shift=24:16:8:0 Console: switching to colour frame buffer device 128x48 fb0: VESA VGA frame buffer device pty: 256 Unix98 ptys configured RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx VP_IDE: IDE controller at PCI slot 00:11.1 PCI: No IRQ known for interrupt pin A of device 00:11.1 VP_IDE: chipset revision 6 VP_IDE: not 100%% native mode: will probe irqs later VP_IDE: VIA vt8235 (rev 00) IDE UDMA133 controller on pci00:11.1 ide0: BM-DMA at 0x1100-0x1107, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x1108-0x110f, BIOS settings: hdc:DMA, hdd:pio hda: FUJITSU MHT2040AT, ATA DISK drive blk: queue c02c3e00, I/O limit 4095Mb (mask 0xffffffff) hdc: TOSHIBA DVD-ROM SD-R6012, ATAPI CD/DVD-ROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: attached ide-disk driver. spurious 8259A interrupt: IRQ7. hda: host protected area => 1 hda: 78140160 sectors (40008 MB) w/2048KiB Cache, CHS=4864/255/63, UDMA(100) Partition check: hda: hda1 hda2 hda3 < hda5 hda6 > hda4 NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 32768) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 276k freed CSLIP: code copyright 1989 Regents of the University of California PPP generic driver version 2.4.2 PPP Deflate Compression module registered PPP BSD Compression module registered Installing knfsd (copyright (C) 1996 okir@monad.swb.de). loop: loaded (max 8 devices) usb.c: registered new driver usbdevfs usb.c: registered new driver hub usb-uhci.c: $Revision: 1.275 $ time 19:44:21 Sep 7 2003 usb-uhci.c: High bandwidth mode enabled usb-uhci.c: USB UHCI at I/O 0x1200, IRQ 10 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: USB UHCI at I/O 0x1300, IRQ 11 usb-uhci.c: Detected 2 ports usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected usb-uhci.c: v1.275:USB Universal Host Controller Interface driver mice: PS/2 mouse device common for all mice usb.c: registered new driver hiddev usb.c: registered new driver hid hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers via-rhine.c:v1.10-LK1.1.19 July-12-2003 Written by Donald Becker http://www.scyld.com/network/via-rhine.html eth0: VIA VT6102 Rhine-II at 0xe300, 00:40:d0:3c:a1:6d, IRQ 10. eth0: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000. ehci_hcd 00:10.3: VIA Technologies, Inc. USB 2.0 ehci_hcd 00:10.3: irq 10, pci mem deea6000 usb.c: new USB bus registered, assigned bus number 3 ehci_hcd 00:10.3: USB 2.0 enabled, EHCI 1.00, driver 2003-Jun-19/2.4 hub.c: USB hub found hub.c: 4 ports detected SCSI subsystem driver Revision: 1.00 Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage USB Mass Storage support registered. hdc: attached ide-scsi driver. scsi0 : SCSI host adapter emulation for IDE ATAPI devices Vendor: TOSHIBA Model: DVD-ROM SD-R6012 Rev: 1M31 Type: CD-ROM ANSI SCSI revision: 02 Attached scsi CD-ROM sr0 at scsi0, channel 0, id 0, lun 0 sr0: scsi3-mmc drive: 24x/24x writer cd/rw xa/form2 cdda tray Uniform CD-ROM driver Revision: 3.12 Via 686a/8233/8235 audio driver 1.9.1-ac3 via82cxxx: Six channel audio available ac97_codec: AC97 Audio codec, id: ALG16 (ALC200/200P) via82cxxx: board #1 at 0xE100, IRQ 5 Journalled Block Device driver loaded hub.c: connect-debounce failed, port 2 disabled NTFS driver v1.1.22 [Flags: R/O MODULE] slmdm: version 2.7.14 Apr 6 2003 16:09:06 (Smart Link Ltd.). slmdm: country set is 0x59 (ITALY). Smart Link AMRMO modem. amrmo: probe 1106:3068 VIA Technologies, Inc. Intel 537 [AC97 Modem] : VIA3058/SmartRiser card... Non-volatile memory driver v1.2 Real Time Clock Driver v1.10e Adding Swap: 586332k swap-space (priority -1) hub.c: new USB device 00:10.1-2, assigned address 2 hub.c: USB hub found hub.c: 4 ports detected hub.c: new USB device 00:10.1-2.1, assigned address 3 input: USB HID v1.10 Keyboard [Logitech USB Receiver] on usb2:3.0 input: USB HID v1.10 Mouse [Logitech USB Receiver] on usb2:3.1 hub.c: new USB device 00:10.1-2.3, assigned address 4 usb.c: USB device 4 (vend/prod 0x43d/0x57) is not claimed by any active driver.