Re: [PATCH] net: davinci: fix building davinci mdio code without CONFIG_OF

[Sekhar Nori <nsekhar@ti.com>]

Hi Arnd,

On Monday 28 May 2018 09:20 PM, Arnd Bergmann wrote:
> Test-building this driver on targets without CONFIG_OF revealed a build
> failure:
> 
> drivers/net/ethernet/ti/davinci_mdio.c: In function 'davinci_mdio_probe':
> drivers/net/ethernet/ti/davinci_mdio.c:380:9: error: implicit declaration of function 'davinci_mdio_probe_dt'; did you mean 'davinci_mdio_probe'? [-Werror=implicit-function-declaration]
> 
> This adjusts the #ifdef logic in the driver to make it build in
> all configurations.
> 
> Fixes: 2652113ff043 ("net: ethernet: ti: Allow most drivers with COMPILE_TEST")
> Signed-off-by: Arnd Bergmann <arnd@arndb.de>

Your patch fixes the issue.

Acked-by: Sekhar Nori <nsekhar@ti.com>

One question below:

> ---
>  drivers/net/ethernet/ti/davinci_mdio.c | 4 +---
>  1 file changed, 1 insertion(+), 3 deletions(-)
> 
> diff --git a/drivers/net/ethernet/ti/davinci_mdio.c b/drivers/net/ethernet/ti/davinci_mdio.c
> index 8ac72831af05..a98aedae1b41 100644
> --- a/drivers/net/ethernet/ti/davinci_mdio.c
> +++ b/drivers/net/ethernet/ti/davinci_mdio.c
> @@ -321,7 +321,6 @@ static int davinci_mdio_write(struct mii_bus *bus, int phy_id,
>  	return ret;
>  }
>  
> -#if IS_ENABLED(CONFIG_OF)
>  static int davinci_mdio_probe_dt(struct mdio_platform_data *data,
>  			 struct platform_device *pdev)
>  {
> @@ -339,7 +338,6 @@ static int davinci_mdio_probe_dt(struct mdio_platform_data *data,
>  
>  	return 0;
>  }
> -#endif
>  
>  #if IS_ENABLED(CONFIG_OF)
>  static const struct davinci_mdio_of_param of_cpsw_mdio_data = {
> @@ -374,7 +372,7 @@ static int davinci_mdio_probe(struct platform_device *pdev)
>  		return -ENOMEM;
>  	}
>  
> -	if (dev->of_node) {
> +	if (IS_ENABLED(CONFIG_OF) && dev->of_node) {
>  		const struct of_device_id	*of_id;
>  
>  		ret = davinci_mdio_probe_dt(&data->pdata, pdev);

I was expecting this one change to fix the issue since the if() block
should be compiled away removing references to davinci_mdio_probe_dt().

The code does get compiled out and there are no references to
davinci_mdio_probe_dt() in the final object when !CONFIG_OF.

But the compile error remains if the #ifdefs you removed above are
installed back. Not sure why.

Thanks,
Sekhar