Re: [PATCH] iio: adc: ad7124: change setup reg allocation strategy

[David Lechner <dlechner@baylibre.com>]

On 9/20/25 6:24 AM, Jonathan Cameron wrote:
> On Wed, 17 Sep 2025 17:05:01 -0500
> David Lechner <dlechner@baylibre.com> wrote:
> 
>> Change the allocation strategy of the 8 SETUP registers from a least-
>> recently-used (LRU) to a first-come-first-served basis.
>>
>> The AD7124 chips can have up to 16 channels enabled at a time in the
>> sequencer for buffered reads, but only have 8 SETUP configurations
>> (namely the OFFSET, GAIN, CONFIG and FILTER registers) that must be
>> shared among the 16 channels.  This means some of the channels must use
>> the exact same configuration parameters so that they can share a single
>> SETUP group of registers.  The previous LRU strategy did not keep track
>> of how many different configurations were requested at the same time,
>> so if there were more than 8 different configurations requested, some
>> channels would end up using the incorrect configuration because the slot
>> assigned to them would also be assigned to a different configuration
>> that wrote over it later.
>>
>> Adding such tracking to solve this would make an already complex
>> algorithm even more complex.  Instead we can replace it with a simpler
>> first-come-first-serve strategy.  This makes it easy to track how many
>> different configurations are being requested at the same time.  This
>> comes at the expense of slightly longer setup times for buffered reads
>> since all setup registers must be written each time when a buffered read
>> is enabled.  But this is generally not considered a hot path where
>> performance is critical, so should be acceptable.
> 
> If I read this correctly, ever time we call postenable()
> this parses the channels enabled and first checks if an existing cfg
> is usable, if not assigns the first unused slot.
> 
> If so, the algorithm is a little more complex than it needs to be because
> it is allowing for holes in the used cfg registers that I don't think
> can occur.

Yes, Nuno noticed this too and had a suggestion on how to simplify it.

> 
> So if we add simple cfg_slots_used variable we can for example jump directly
> to the next unused slot if we don't find a match and we can use this
> as the loop limit to save on checking a bunch of zeros after that aren't
> in use.

There are only 8 available config slots, so I didn't consider such
optimization. But we could perhaps do this even without adding an
extra variable.

> 
> Maybe I'm missing something?
> 
> In general the approach you have here feels sensible.
> 
> Jonathan
>