Re: [PATCH v4 2/4] arm64: Work around Falkor erratum 1003

[Marc Zyngier <marc.zyngier@arm.com>]

On 31/01/17 17:48, Christopher Covington wrote:
> On 01/31/2017 07:37 AM, Mark Rutland wrote:
>> On Wed, Jan 25, 2017 at 10:52:30AM -0500, Christopher Covington wrote:
>>> The Qualcomm Datacenter Technologies Falkor v1 CPU may allocate TLB entries
>>> using an incorrect ASID when TTBRx_EL1 is being updated. When the erratum
>>> is triggered, page table entries using the new translation table base
>>> address (BADDR) will be allocated into the TLB using the old ASID. All
>>> circumstances leading to the incorrect ASID being cached in the TLB arise
>>> when software writes TTBRx_EL1[ASID] and TTBRx_EL1[BADDR], a memory
>>> operation is in the process of performing a translation using the specific
>>> TTBRx_EL1 being written, and the memory operation uses a translation table
>>> descriptor designated as non-global. EL2 and EL3 code changing the EL1&0
>>> ASID is not subject to this erratum because hardware is prohibited from
>>> performing translations from an out-of-context translation regime.
>>>
>>> Consider the following pseudo code.
>>>
>>>   write new BADDR and ASID values to TTBRx_EL1
>>>
>>> Replacing the above sequence with the one below will ensure that no TLB
>>> entries with an incorrect ASID are used by software.
>>>
>>>   write reserved value to TTBRx_EL1[ASID]
>>>   ISB
>>>   write new value to TTBRx_EL1[BADDR]
>>>   ISB
>>>   write new value to TTBRx_EL1[ASID]
>>>   ISB
>>>
>>> When the above sequence is used, page table entries using the new BADDR
>>> value may still be incorrectly allocated into the TLB using the reserved
>>> ASID. Yet this will not reduce functionality, since TLB entries incorrectly
>>> tagged with the reserved ASID will never be hit by a later instruction.
>>
>> Based on my understanding that entries allocated to the reserved ASID
>> will not be used for subsequent page table walks (and so we don't have
>> asynchronous behaviour to contend with), this sounds fine to me.
>>
>> Thanks for taking the time to clarify the details on that.
>>
>>> Based on work by Shanker Donthineni <shankerd@codeaurora.org>
>>>
>>> Signed-off-by: Christopher Covington <cov@codeaurora.org>
>>> ---
>>>  Documentation/arm64/silicon-errata.txt |  1 +
>>>  arch/arm64/Kconfig                     | 11 +++++++++++
>>>  arch/arm64/include/asm/assembler.h     | 23 +++++++++++++++++++++++
>>>  arch/arm64/include/asm/cpucaps.h       |  3 ++-
>>>  arch/arm64/include/asm/mmu_context.h   |  8 +++++++-
>>>  arch/arm64/kernel/cpu_errata.c         |  7 +++++++
>>>  arch/arm64/mm/context.c                | 11 +++++++++++
>>>  arch/arm64/mm/proc.S                   |  1 +
>>>  8 files changed, 63 insertions(+), 2 deletions(-)
>>
>> Don't we need to use pre_ttbr0_update_workaround in <asm/asm-uaccess.h>
>> for CONFIG_ARM64_SW_TTBR0_PAN? We implicitly switch to the reserved ASID
>> for the empty table in __uaccess_ttbr0_disable.
>>
>> That also means we have to invalidate the reserved ASID so as to not
>> accidentally hit while uaccess is disabled.
> 
> The CPU in question (Falkor v1) has hardware PAN support. Do we need
> to worry about including the workaround in the SW PAN code in that case?

Given that all ARMv8 CPUs can support SW_PAN, it is more likely to be
enabled than the ARMv8.1 PAN. I'd vote for supporting the workaround in
that case too, and hope that people do enable the HW version.

Thanks,

	M.
-- 
Jazz is not dead. It just smells funny...