Re: [BUG] staging: rtl8192e: W_DISABLE# does not work after stop/start

[Dan Carpenter <error27@gmail.com>]

On Fri, Apr 07, 2023 at 11:02:05PM +0200, Philipp Hortmann wrote:
> When loading the driver for rtl8192e, the W_DISABLE# switch is working as
> intended. But when the WLAN is turned off in software and then turned on
> again the W_DISABLE# does not work anymore.
> 
> Reason for this is that in the function _rtl92e_dm_check_rf_ctrl_gpio()
> checking this every two seconds is an conditional return.
> 
> 	if (priv->bfirst_after_down) {
> 		priv->bfirst_after_down = true; // PH: useless line
> 		return;
> 	}
> 
> 	tmp1byte = rtl92e_readb(dev, GPI); // PH: GPI for W_DISABLE#
> 
> bfirst_after_down is set true when switching the WLAN off in software. But
> it is not set to false again when WLAN is turned on again.
> 

Is there a question here?  You're like the expert on this driver and you
seem to have figured out the solution...  I'm confused.

regards,
dan carpenter