Linux version 2.6.8.1 (chewie@Loki.local) (gcc version 3.4.1) #1 Mon Aug 23 15:43:57 CEST 2004 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009fc00 (usable) BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001ffc0000 (usable) BIOS-e820: 000000001ffc0000 - 000000001fff8000 (ACPI data) BIOS-e820: 000000001fff8000 - 0000000020000000 (ACPI NVS) BIOS-e820: 00000000ffb80000 - 00000000ffc00000 (reserved) BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved) 511MB LOWMEM available. On node 0 totalpages: 131008 DMA zone: 4096 pages, LIFO batch:1 Normal zone: 126912 pages, LIFO batch:16 HighMem zone: 0 pages, LIFO batch:1 DMI 2.3 present. ACPI: RSDP (v000 AMI ) @ 0x000ff980 ACPI: RSDT (v001 DELL ZUUL 0x20020611 MSFT 0x00001011) @ 0x1fff0000 ACPI: FADT (v001 DELL ZUUL 0x20020611 MSFT 0x00001011) @ 0x1fff1000 ACPI: BOOT (v001 DELL ZUUL 0x20020611 MSFT 0x00001011) @ 0x1fff4000 ACPI: DSDT (v001 D815EA EA81510A 0x00000013 MSFT 0x0100000b) @ 0x00000000 Built 1 zonelists Kernel command line: ro root=/dev/hda2 Local APIC disabled by BIOS -- reenabling. Found and enabled local APIC! Initializing CPU#0 CPU 0 irqstacks, hard=c0325000 soft=c0324000 PID hash table entries: 2048 (order 11: 16384 bytes) Detected 731.080 MHz processor. Using tsc for high-res timesource Console: colour VGA+ 80x25 Dentry cache hash table entries: 131072 (order: 7, 524288 bytes) Inode-cache hash table entries: 65536 (order: 6, 262144 bytes) Memory: 515968k/524032k available (1373k kernel code, 7296k reserved, 452k data, 340k init, 0k highmem) Checking if this processor honours the WP bit even in supervisor mode... Ok. Calibrating delay loop... 1441.79 BogoMIPS Mount-cache hash table entries: 512 (order: 0, 4096 bytes) CPU: After generic identify, caps: 0383fbff 00000000 00000000 00000000 CPU: After vendor identify, caps: 0383fbff 00000000 00000000 00000000 CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 256K CPU: After all inits, caps: 0383fbff 00000000 00000000 00000040 Intel machine check architecture supported. Intel machine check reporting enabled on CPU#0. CPU: Intel Pentium III (Coppermine) stepping 03 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. enabled ExtINT on CPU#0 ESR value before enabling vector: 00000000 ESR value after enabling vector: 00000000 Using local APIC timer interrupts. calibrating APIC timer ... ..... CPU clock speed is 730.0868 MHz. ..... host bus clock speed is 132.0885 MHz. NET: Registered protocol family 16 PCI: PCI BIOS revision 2.10 entry at 0xfda95, last bus=2 PCI: Using configuration type 1 mtrr: v2.0 (20020519) ACPI: Subsystem revision 20040326 ACPI: IRQ9 SCI: Level Trigger. ACPI: Interpreter enabled ACPI: Using PIC for interrupt routing ACPI: PCI Root Bridge [PCI0] (00:00) PCI: Probing PCI hardware (bus 00) PCI: Transparent bridge - 0000:00:1e.0 ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT] ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.PCI1._PRT] ACPI: Power Resource [URP1] (off) ACPI: Power Resource [URP2] (off) ACPI: Power Resource [FDDP] (off) ACPI: Power Resource [LPTP] (off) ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 6 7 9 10 *11 12) ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 *9 10 11 12) ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 5 6 7 9 10 11 12) *0, disabled. ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 6 7 9 *10 11 12) ACPI: PCI Interrupt Link [LNKE] (IRQs 3 4 5 6 7 9 10 11 12) *0, disabled. ACPI: PCI Interrupt Link [LNKF] (IRQs 3 4 5 6 7 9 10 11 12) *0, disabled. ACPI: PCI Interrupt Link [LNKG] (IRQs *3 4 5 6 7 9 10 11 12) ACPI: PCI Interrupt Link [LNKH] (IRQs 3 4 5 6 7 9 10 11 12) *0, disabled. PCI: Using ACPI for IRQ routing ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 10 ACPI: PCI interrupt 0000:00:1f.2[D] -> GSI 10 (level, low) -> IRQ 10 ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 9 ACPI: PCI interrupt 0000:00:1f.3[B] -> GSI 9 (level, low) -> IRQ 9 ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11 ACPI: PCI interrupt 0000:01:00.0[A] -> GSI 11 (level, low) -> IRQ 11 ACPI: PCI Interrupt Link [LNKG] enabled at IRQ 3 ACPI: PCI interrupt 0000:02:0a.0[A] -> GSI 3 (level, low) -> IRQ 3 ACPI: PCI interrupt 0000:02:0c.0[A] -> GSI 9 (level, low) -> IRQ 9 Simple Boot Flag at 0x7a set to 0x80 Real Time Clock Driver v1.12 Linux agpgart interface v0.100 (c) Dave Jones agpgart: Detected an Intel i815 Chipset, but could not find the secondary device. agpgart: Detected an Intel i815 Chipset. agpgart: Maximum main memory to use for agp memory: 439M agpgart: AGP aperture is 64M @ 0xf8000000 Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A Using anticipatory io scheduler Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 loop: loaded (max 8 devices) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ICH2: IDE controller at PCI slot 0000:00:1f.1 ICH2: chipset revision 2 ICH2: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA hda: WDC WD400EB-00CPF0, ATA DISK drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hdc: DV-516E, ATAPI CD/DVD-ROM drive hdd: PLEXTOR CD-R PX-W1610A, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 hda: max request size: 128KiB hda: 78165360 sectors (40020 MB) w/2048KiB Cache, CHS=65535/16/63, UDMA(100) hda: hda1 hda2 hda3 mice: PS/2 mouse device common for all mice serio: i8042 AUX port at 0x60,0x64 irq 12 input: ImPS/2 Generic Wheel Mouse on isa0060/serio1 serio: i8042 KBD port at 0x60,0x64 irq 1 input: AT Translated Set 2 keyboard on isa0060/serio0 NET: Registered protocol family 2 IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 65536) NET: Registered protocol family 1 NET: Registered protocol family 17 kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 340k freed ACPI: Power Button (FF) [PWRF] ACPI: Processor [CPU1] (supports C1) usbcore: registered new driver usbfs usbcore: registered new driver hub USB Universal Host Controller Interface driver v2.2 ACPI: PCI interrupt 0000:00:1f.2[D] -> GSI 10 (level, low) -> IRQ 10 uhci_hcd 0000:00:1f.2: Intel Corp. 82801BA/BAM USB (Hub #1) PCI: Setting latency timer of device 0000:00:1f.2 to 64 uhci_hcd 0000:00:1f.2: irq 10, io base 0000ef80 uhci_hcd 0000:00:1f.2: new USB bus registered, assigned bus number 1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected EXT3 FS on hda2, internal journal usb 1-1: new low speed USB device using address 2 Adding 522104k swap on /dev/hda3. Priority:-1 extents:1