Re: [PATCH net 1/7] net: hns3: fix pause config problem after autoneg disabled

["huangguangbin (A)" <huangguangbin2@huawei.com>]

On 2021/10/28 20:30, Andrew Lunn wrote:
>> Hi Andrew, thanks very much for your guidance on how to use pause autoneg,
>> it confuses me before because PHY registers actually have no separate setting
>> bit of pause autoneg.
>>
>> So, summarize what you mean:
>> 1. If pause autoneg is on, driver should always use the autoneg result to program
>>     the MAC. Eventhough general autoneg is off now and link state is no changed then
>>     driver just needs to keep the last configuration for the MAC, if link state is
>>     changed and phy goes down and up then driver needs to program the MAC according
>>     to the autoneg result in the link_adjust callback.
>> 2. If pause autoneg is off, driver should directly configure the MAC with tx pause
>>     and rx pause. Eventhough general autoneg is on, driver should ignore the autoneg
>>     result.
>>
>> Do I understand right?
> 
> Yes, that fits my understanding of ethtool, etc.
> 
> phylink tried to clear up some of these problems by fully implementing
> the call within phylink. All the MAC driver needs to provide is a
> method to configure the MAC pause settings. Take a look at
> phylink_ethtool_set_pauseparam() and the commit messages related to
> that.
> 
> 	Andrew
> .
> 
Ok, thanks!