Sylvain Meyer a écrit : > You should use video=intelfb:accel=0 (zero). Could you set the "Intel > driver Debug Messages" on on your linux kernel config ? You must have > the output > intelfb: options: vram = 4, accel = 0, hwcursor = 1, fixed = 0, noinit = 0 > or similar in the dmesg output (the important is accel = 0, for sure). > In this case the hw acceleration is off. Ok, dmesg says accel = 0. But chvt 1 gives a black screen, no text at all. chvt [23456] gives a dirty screen as before. dmesg attached (2.6.12-rc1-mm1 with CONFIG_FB_INTEL_DEBUG). By the way, cat /sys/module/intelfb/parameters/accel still says Y. And cat /sys/module/intelfb/parameters/mode gives the following oops (I think it is related to CONFIG_FB_INTEL_DEBUG): c01cc2b2 PREEMPT Modules linked in: videodev i915 tun ipt_MASQUERADE iptable_nat ipt_state ip_conntrack iptable_filter ip_tables floppy uhci_hcd ehci_hcd dm_mod snd_intel8x0 snd_ac97_codec CPU: 0 EIP: 0060:[] Not tainted VLI EFLAGS: 00010297 (2.6.12-rc1-mm1=Macvin) EIP is at vsnprintf+0x332/0x4d0 eax: f05fc051 ebx: 0000000a ecx: f05fc051 edx: fffffffe esi: dc4b4000 edi: 00000000 ebp: ffffffff esp: dec15ea8 ds: 007b es: 007b ss: 0068 Process cat (pid: 3711, threadinfo=dec15000 task=c261ea90) Stack: db34a480 00000000 00008124 c013dc80 c1389680 0000002c 00000000 c013e4e4 ffffffff ffffffff 00000000 c14aa400 dc4b4000 00000001 c01cc558 dc4b4000 23b4c000 c035d872 dec15f04 c012af25 dc4b4000 c035d871 f05fc051 c012b337 Call Trace: [] prep_new_page+0x60/0x70 [] buffered_rmqueue+0xf4/0x1e0 [] sprintf+0x28/0x30 [] param_get_charp+0x25/0x30 [] param_attr_show+0x27/0x60 [] module_attr_show+0x7a/0xe0 [] fill_read_buffer+0x5d/0xa0 [] sysfs_read_file+0x2d/0x70 [] vfs_read+0xb6/0x170 [] sys_read+0x51/0x80 [] syscall_call+0x7/0xb Code: 00 83 cf 01 89 44 24 24 eb bb 8b 44 24 48 8b 54 24 20 83 44 24 48 04 8b 08 b8 6c 65 35 c0 81 f9 ff 0f 00 00 0f 46 c8 89 c8 eb 06 < 80> 38 00 74 07 40 4a 83 fa ff 75 f4 29 c8 83 e7 10 89 c3 75 20 Regards, Brice